552029
14
Zoom out
Zoom in
Previous page
1/20
Next page
14
09/2013
40°C, 3
C,
cold
Normally besmirched articles (incl. Synthetic and wool).
Select the washing program and temperature according to the fabrics and soiling degree. Generally
applies: as higher the temperature setting, as higher the energy consumption.
Capacity
Do not overload the washing machine; otherwise the laundry will not get clean.
The ’table of washing cycles‘ shows the capacities.
Start up the Washing Machine
- Connect the power.
- Check if water pipes are connected properly. Open the tap completely.
- Open the door, and put the clothes into the drum one by one.
- Close the door, and fill suitable amount of detergent and fabric softener into dispenser.
Close the drawer.
- Select a washing programme you need by turning the knob (1).
- Select the temperature by turning the ‘Temperature knob’ (2).
- Then press the spin button (3) to select the desired spin speed level.
Select and set the spin speed level:
WA 5814: 0spin stop-400-600-800-1.000-1.200-1.400 rpm
In 0spin stop setting the machine does not spin.
The higher the revolutions, the drier you are washing, but also more noise.
Please note: Protect your washing with lower spinning revolutions.
- If necessary select an option:
rinse+, no rinse, pre-wash, soak
Please note: The additional options are not available for each washing programme.
- Press ’Start/Pause‘ button (6) to start the washing machine.
Change the washing programme
It is possible to stop the wash cycle by pressing the Start/Pause button. The machine will go to
standby mode. If there is a need to change the programme, the knob No. 1 must be turned to OFF
position before selecting new programme. After select a new programme press the 'Start/Pause'- but-
ton (6) to start.
By pressing the 'Start/Pause'- button (6) you can stop the washing machine. The machine will go to
standby mode. To start the program this button must pressing again.
Door Lock
When the machine is started, the door lock is locked though you press the 'Start/Pause' button.
Turn the programme knob (1) to position off and the door lock is unlocked in few minutes.
- When the temperature inside the drum is above 50°C, the door lock is locked.
- When the water is above a certain level, the door lock is locked.
ATTENTION:
Do not try to open the door when the washing cycle is not finished or power supply is cut off during the
washing cycle, because the temperature may be high and you may be scalded.
End of Washing
When washing cycle is finished the machine will change to a standby status and the power will be off.
Before opening the door always check that the water has been drained. The door lock will deactivated
and the LED is off.
Turn Off the Washing Machine
- Turn off the device by positioning the program selector knob to position ‘0’.
- Close the water supply!
- When machine turned off, leave the door ajar for the better preservation of the seal and preventing
musty odours.
- Remove the power plug when the machine is not used for long periods.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann WA 5814 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann WA 5814 in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann WA 5814

Bomann WA 5814 User Manual - German - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info