552032
14
Zoom out
Zoom in
Previous page
1/18
Next page
14
03/2014
Cleaning the Water Inlet Filter
Cleaning the Drain Pump Filter, Remove Foreign Bodies
The foreign body trap in the drain pump prevents that rinsed parts blocks the drain pump system.
Clean the trap periodically to ensure the normal operation of washing machine.
Check the foreign body trap if the water in the wash cycle will not drain or increased noise can be
heard during the pumping.
CAUTION: First, drain the water and then open the trap to clean away foreign bodies.
Take care if the drained water is hot.
1.Disconnect the machine
From the mains electricity sup-
ply and open the pump cover
with a screwdriver.
2. Place a container under the pump.
Turn the fastener of the trap
to the left. Look for water leaks!
3. Remove the filter and
clean it carefully from any
foreign body.
4. Reattach the filter again and look for a tight fit so that no water can escape. Close the bottom cover
plate.
The filter should be cleaned every 2 months or so, or when there is fault that the “Rinse” and “Spin”
LEDs flicker.
ATTENTION: Never operate the appliance without filter.
Cold conditions
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
- Turn off the water tap.
- Unscrew the inlet hose.
- Unhook the drain hose from the rear support and position the end of this hose and that of the inlet
hose in a bowl. Run the spin programme.
- Disconnect the appliance.
- Screw the inlet hose and reposition the drain hose.
- When you intend to start the machine up again, make sure that the room temperature is above
C.
Repairs
CAUTION
Servicing of electric devices must be conducted by qualified experts only. Incorrect or improper repairs
constitute a risk for the user and will void the warranty!
Use pointed nose pliers to withdraw the plastic filter. Cleaning put back
and secure. This filter should be checked every 6 months or so, or more
often if there are frequent interruptions to the water supply.
NOTE: The filter must be put back in place after cleaning.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann WA 5710 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann WA 5710 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann WA 5710

Bomann WA 5710 User Manual - German - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info