688060
20
Zoom out
Zoom in
Previous page
1/28
Next page
20
Installation
InstallationInstallation
Installation
Condition
ConditionCondition
Conditions for the installation location
s for the installation locations for the installation location
s for the installation location
Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
- Gap to the back approx. 5 cm and to the side
walls each approx. 10 cm;
- Place the appliance so that the appliance door
can open without being impeded.
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter “Technical Data” or to the rating label
located in the interior or on the rear side of the
appliance.
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
Avoid the installation:
Avoid the installation:Avoid the installation:
Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Height adjustment of the door
Height adjustment of the doorHeight adjustment of the door
Height adjustment of the door
Before adjusting the height of the door, rotate the
downward adjusting nut clockwise for 2 circles with a
wrench, and loosen the downward adjusting nut.
Rotate the upward adjusting nut to adjust the height,
and then tighten the downward adjusting nut coun-
terclockwise again.
1. When the door of refrigerator is low:
Open the door, use the accompanying wrench to
rotate the upward adjusting nut counterclockwise,
to move it upward until it is parallel and level.
2. When the door of refrigerator is high:
Open the door, use the accompanying wrench to
rotate the upward adjusting nut clockwise, to
move it downward, until it is parallel and level.
The total height can be adjusted to 5 mm!
The total height can be adjusted to 5 mm!The total height can be adjusted to 5 mm!
The total height can be adjusted to 5 mm!
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
WARNING:
WARNING:WARNING:
WARNING:
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
In case of disconnection or power failure:
- Wait for approx. 5 minutes before restarting.
- Check the operation settings.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann SBS 2211 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann SBS 2211 in the language / languages: English, German as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info