687810
19
Zoom out
Zoom in
Previous page
1/24
Next page
19
Ensure sufficient ventilation at the bottom and
rear side. Never block ventilation openings.
Do not adjust the temperature colder than neces-
sary.
Do not leave open the door for longer than re-
quired.
The appliance should be defrosted regularly if
necessary.
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning
CleaningCleaning
Cleaning
and Maintenance
and Maintenanceand Maintenance
and Maintenance
WARNING:
WARNING:WARNING:
WARNING:
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!Risk of electric shock!
Risk of electric shock! Hot steam could damage
the plastic parts.
The appliance must be dry before restarting oper-
ation.
CAUTION:
CAUTION:CAUTION:
CAUTION:
Do not use a wire brush or other sharp, abrasive
items.
Do not use any acidic or abrasive detergents.
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interiorCleaning the appliance including interior
Cleaning the appliance including interior
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfibre cloth without cleaning agent.
Remove the appliance content and storage it at a
cool location.
After everything was thoroughly dried, you can
restart the operation.
Defrosting
DefrostingDefrosting
Defrosting
CAUTION:
CAUTION:CAUTION:
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
To achieve better cooling and to save energy, defrost
the appliance
regularly manual as follows:
To start the defrosting process turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
Remove the food items and keep covered at a
cool location.
Once the ice has melted, empty the condensation
drip tray below the chilling compartment; wipe up
the condensation water and dry the unit interior.
Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the bulb
Changing the bulbChanging the bulb
Changing the bulb
Lamp data:
Lamp data:Lamp data:
Lamp data:
max. 1
max. 1max. 1
max. 10
00
0
W / 220
W / 220W / 220
W / 220-
--
-240 V~
240 V~240 V~
240 V~
Loosen the screw and remove
the remove the lamp cover
carefully.
Change the defective bulb.
Replace the lamp cover properly and fit it.
Troubleshooting
TroubleshootingTroubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialistBefore you contact an authorized specialist
Before you contact an authorized specialist
Problem
ProblemProblem
Problem
Cause / Action
Cause / ActionCause / Action
Cause / Action
Appliance is
not working
properly or
at all
∙ Check the power supply / temperature
setting / ambient temperature.
∙ Unblock the ventilation openings,
install the appliance freely.
Loading is
too warm
∙ Check the temperature setting / ambi-
ent temperature. ∙ Open the door only
as long as necessary.
Loud noise
during oper-
ation
∙ Check the appliance position.
∙ See the section “Operating noise”.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KS 7230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KS 7230 in the language / languages: English, German as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info