552091
10
Zoom out
Zoom in
Previous page
1/11
Next page
10
07/2012
Please do as follows:
- Remove all food and keep covered at a cool location.
- Use warm water and a mild detergent for cleaning the interior (including rear side and bottom).
- After thorough drying, restart operation.
WARNING:
- Do not bend the cooling coils.
- Do not use arenaceous abrasives.
LED light
If the LED light bulb is damaged, DO NOT CHANG IT BY THE USER!
Changing the LED light bulb carry out by inexperienced persons may cause injury or serious malfunc-
tioning. It must be replaced by qualified persons in order to avoid a hazard. Contact your local Service
Force Center for help.
Repairs
WARNING: Servicing of electric devices must be conducted by qualified experts only. Incorrect or
improper repairs constitute a risk for the user and will void the warranty!
What if . . . Troubleshooting
The design of the device ensures a trouble-free operation as well as a long life cycle. Nevertheless, if
any defect occurs during operation, please check if it is caused by improper operation.
The following problems can be solved by you by checking for the possible cause.
PROBLEM
POSSIBLE CAUSE
SOL
U
TION
The device is
not working
properly or at
all
Is the plug securely connected to the mains?
Has the safety mechanism of the wall socket
been triggered?
Is the temperature control properly set?
Is the place unqualified?
Do food items or shelves and/or drawers
prevent the door from closing properly?
Is the ventilation of the device hedged?
Connect the plug properly to the sock
et, turn
on the fuse, and contact a technician if nec-
essary.
Check the settings.
Check the ambient temperature.
Arrange the food or shelves and/or drawers
properly.
Clear the ventilation slits, install the device
freely.
Appliances
cools too
much
Is the temperature control set properly? Check the temperature setting.
The food is
too warm
Is the temperature control set properly?
Door was open for an extended period.
A large quantity of warm food was placed in
the appliances within the last 24 hours.
The appliance is near a heat source.
Check the temperature setting.
Open the door only as long as necessary.
Turn the control panel to a colder setting tem-
porally.
Please refer to the ‘Installation’ section.
Loud noise
during opera-
tion
Does the device not stand vertical or horizon-
tal?
Adjust the feet accordingly.
Liquid flow sounds in the cooling circuit are
normal.
Water on the
bottom
Is the temperature control set properly?
Is the condensate flume clogged?
Check the temperature setting.
Clean the discharge opening with a pipe
cleaner or knitting needle.
Light does not
work
Is the plug not connected to the mains?
Has the safety mechanism of the wall socket
been triggered?
Is the light bulb defect?
Connect the plug properly to the sock
et, turn
on the fuse, and contact a technician if nec-
essary.
Disconnect
the plug and replace the light bulb
(see ‘Changing the light bulb’).
The sides of
housing be-
comes warm-
ly.
These devices are not equipped with the conventional grating on the back.
The
refrigeration cycle takes place in the foaming. The heat exchangers are installed
in the
housing covered. The device does not generate cold, but cut the interior heat. This heat
must be dissipated. If your device this heat is dissipated through the housing areas
Note: On days of high humidity, condensation might occur on the outer surface of the device. This is
no malfunction; you may simply wipe the water off.
If a problem still persists after following the steps above, please contact your distributor or a techni-
cian.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KG 180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KG 180 in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann KG 180

Bomann KG 180 User Manual - German - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info