Manual Bomann KB 389 (page 17 of 52) (English, German, Dutch, French)

688025

Zoom out

Zoom in

1/52

ficient cooling operation at low power consump-

tion. Enough clearance is necessary.

- Gap to the back and to the side walls each ap-

prox. 5 cm;

- Place the appliance so that the appliance door

can open without being impeded.

• Only install at a location with an ambient tempera-

ture suitable for the climate class of the appliance.

For information on the climate class, please refer

to chapter “Technical Data” or to the rating label

located in the interior or on the rear side of the

appliance.

• Place the appliance on a steady and safe surface.

If the appliance is not horizontally leveled, adjust

the feet accordingly.

• Avoid the installation:

Avoid the installation:Avoid the installation:

Avoid the installation:

- near heaters, next to a stove, direct sunlight or

any other heat sources;

- at locations with high humidity (e.g. outdoors,

bathroom), as metal parts would be suscepti-

ble to corrosion under such circumstances;

- near volatile or flammable materials (e.g. gas,

fuel, alcohol, paint, etc.), in rooms which may

have poor air circulation (e.g. garages).

- Do not expose the appliance any weather.

Electrical connection

Electrical connectionElectrical connection

Electrical connection

WARNING:

WARNING:WARNING:

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

electric electric

electric

shock

shockshock

shock!

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

CAUTION

CAUTIONCAUTION

CAUTION:

In case of disconnection or power failure:

- Wait for approx. 5 minutes before restarting.

- Check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Reverse the

Reverse the Reverse the

Reverse the door o

door odoor o

door opening

peningpening

pening

If required, the door opening can be moved from the

right (supplied condition) to the left side.

WARNING:

WARNING:WARNING:

WARNING:

When replacing the door stop, the appliance must be

disconnected from the power supply first.

NOTE

NOTENOTE

NOTE:

• Ask another person to assist.

•

You possibly need:

screw wrench, Phillips screw-

driver as well as a thin-blade screwdriver.

• Remove the blind cap (1) and the hinge cover (2).

• Dismount the upper door hinge (4) by loosening

the screws (3). Open the appliance door a little

and lift it out of the lower door hinge.

• Displace the blind plug (9) of the appliance door

accordingly. Place the appliance door safely

aside.

• Tilt the appliance slightly backwards and block it

in this position. Unscrew the feet (7+8).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KB 389 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bomann KB 389 Manual

Product: