814343
20
Zoom out
Zoom in
Previous page
1/28
Next page
20
WARNING:
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter
“Cleaning and Maintenance”
.
Starting the appliance
Connect the appliance to the power supply.
Set the operating conditions. See also the follow-
ing sections.
Control overview
1
Control lamp lights up
when the compressor is
running.
2
Temperature control
regulates the freezer
temperature.
Settings
Position [ 0 ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power levels control the different values of the
internal temperature.
Power level
Temperature range
1
approx. -8°C -12°C
2, 3
approx. -12°C -15°C
4
approx. -15°C -18°C
5, 6
approx. -18°C -20°C
7*
approx. -20°C -25°C
*Beware at level 7: the compressor is running continuously.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible inter-
nal temperature (= highest power level) until the ap-
pliance has reached the desired operating tempera-
ture. It is recommended to reset to a medium power
level afterwards, then you can easily make any tem-
perature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
best. A high power level also increases energy con-
sumption.
To be able to check the cooling performance, you
ideally need a freezing thermometer. Place it in the
freezer basket.
The ideal temperature is -18°C. A less cold tempera-
ture setting may shorten food durability.
Equipment
The freezer basket facilitates the sorting of small-
sized frozen food and allows faster access to fre-
quently needed frozen food.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GT 7337 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GT 7337 in the language / languages: English, German as an attachment in your email.

The manual is 0.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info