552105
20
Zoom out
Zoom in
Previous page
1/25
Next page
6
03/2012
An expert knows these relations and will execute the tests with special measurement instruments in
accordance with the regulations in place.
MANUFACTURER DATA
Product is subject to changes and improvements.
INSTALLATION
Location
Sufficient ventilation around the device is necessary in order for the heat to
dissipate properly and to guarantee efficient cooling operation at low power
consumption. For this purpose, leave sufficient space around the device.
Minimum clearance of 7,5 cm between rear side and wall,
at least 10 cm on both sides and 10 cm on top of the device.
Leave proper space in front of the device in order to open the
door at an angle of 160°.
IMPORTANT
Do not expose the device to direct sunlight.
Do not place near heaters, next to a stove or any other heat sources.
Do not use the device outdoors.
Only install at a location with an ambient temperature suitable for the climate class of the device.
For information on the climate class, please refer to chapter “Specifications“ or to the rating label
located in the interior or on the rear side of the device.
Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be
susceptible to corrosion under such circumstances.
Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)
and in rooms which may have poor air circulation (e.g. garages).
Only place on a steady and safe surface.
If the device is not horizontally leveled, adjust the feet accordingly.
Electrical connection
The kind of current (AC) and the voltage must be conform with the data of the rating label, located
inside or outside on the back of the unit. In case of heavy voltage fluctuations, it is recommended to
use an automatic alternating current regulator.
The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must be
freely accessible.
Mains cable
Do not extend or roll up the cable during operation.
Also, the cable must not be near the compressor on the rear side, since latter one gets hot during
operation. In case of any contact, the isolation would be damaged resulting in electric leakage.
The use of extension cables is not recommended.
Do not connect the device to the mains with wet hands.
Install the device for the wall socket to be freely accessible.
Leveling
The appliance should be level in order to eliminate vibration. To make the appliance level, it
should be upright and both adjusters should be in stable contact with the floor. You can also
adjust the level by unscrewing the appropriate level adjustment in the front (use your fingers or a
suitable spanner).
REVERSE THE DOOR OPENING
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected from the power supply. Always unplug
the device first.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann GS 176 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann GS 176 in the language / languages: German as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info