651974
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Turn the screws 4 x ST4*25 mm as far as these
stick out about 10 mm from the wall.
Hang up the hood. Check the secure fitting, the
horizontal position and tighten first the upper and
then the lower screws through the hood body.
Remove the protective foil from the ducts.
Put on the outer (lower) duct and fix
it laterally to the hood with the
screws 2 x ST4*8.
For the extraction mode:
For the extraction mode:For the extraction mode:
For the extraction mode:
Attach a flexible extraction hose (not
supplied) with an inner diameter of
Ø120 mm onto the connecting piece.
Slide the inner (upper) duct along the
slide fixture into the outer (lower)
duct. Make sure that the inner duct is
aligned with the vents at the top.
Determine the extension length of the duct cover
by pulling up the inner duct or sliding back into the
outer duct.
Attach the mounting rail at the upper duct ending.
Drill mounting holes 2 x Ø8 mm and insert the
dowel pins. Use the screws 2 x ST4*25 mm to se-
cure the rail.
For the extrac
For the extracFor the extrac
For the extraction mode:
tion mode:tion mode:
tion mode:
Check the correct position of the flexible extrac-
tion hose and connect it with the extraction out-
let to the outside.
Pull the inner duct upwards and fasten the duct
cover laterally to the previously
mounted rail using the screws 2 x
ST4*10 mm.
Installing the activated carbon
Installing the activated carbonInstalling the activated carbon
Installing the activated carbon
filter for recirculation
filter for recirculation filter for recirculation
filter for recirculation
mode
modemode
mode
Remove the aluminum grease filter.
Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
Reinstall the aluminum grease filter.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
The cooker hood is operated via push buttons.
Power level
Power levelPower level
Power level
0
00
0
off
1
11
1
low
2
22
2 medium 3
33
3 high
Lighting
LightingLighting
Lighting
on / off
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DU 671 G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DU 671 G in the language / languages: English, German as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info