Manual Bomann DU 652.1 (page 19 of 24) (English, German)

688077

Zoom out

Zoom in

1/24

• For mounting the hood drill in total 9x mounting

holes with approx. 8 mm diameter into the wall.

Insert the supplied dowels.

• Affix the brackets (01) for the hood body and (02)

for the upper shaft end at the pre-marked posi-

tions using the screws 5x ST4x40mm

(Fig.

(Fig. (Fig.

(Fig. 1

))

)

• Before inserting the hood, affix the connection

piece with the non-return valves from the top of

the extraction duct.

For the exhaust mode (Fig. 2):

For the exhaust mode (Fig. 2):For the exhaust mode (Fig. 2):

For the exhaust mode (Fig. 2):

• Hereupon a flexible exhaust hose (supplied) with

an inner diameter of 150 mm must be attached.

• Hang up the hood body. Check the secure hold

and the horizontal position

(Fig.

(Fig. (Fig.

(Fig. 3

))

)

• Secure the housing with the screws 2x ST4*30

through the hood body

(Fig. 4)

(Fig. 4)(Fig. 4)

(Fig. 4)

• Fasten the outer (lower) shaft with the bracket

(03) using the metal screws 2x ST4*8

(Fig. 5

(Fig. 5(Fig. 5

(Fig. 5).

).).

• Put the shaft unit on and fasten the shaft bracket

(03) with the screws 2x ST4*40

(Fig.

(Fig. (Fig.

(Fig. 6

))

)

For the exhaust mode

For the exhaust modeFor the exhaust mode

For the exhaust mode:

• Check the correct position of the exhaust hose

and connect it with the outlet opening.

• Pull up the inner shaft and fix the shaft cover to

the side with the bracket (02) using the screws

2x ST4*8

(Fig. 7

(Fig. 7(Fig. 7

(Fig. 7)

))

)

Installing the activated carbon

Installing the activated carbonInstalling the activated carbon

Installing the activated carbon

filter for recirculation

filter for recirculation filter for recirculation

filter for recirculation

mode

modemode

mode

• Remove the aluminum grease filter (see “Clean-

ing the aluminum grease filter).

•

Place the carbon filter onto the air

intake of the extraction duct.

Make sure that the mounting pins

on the extraction duct engage the mounting slots

of the carbon filter. Turn the filter clockwise until it

clicks into place.

• Reinstall the aluminum grease filter.

Electrical connection

Electrical connectionElectrical connection

Electrical connection

WARNING:

WARNING:WARNING:

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

electric electric

electric

shock

shockshock

shock!

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Startup / Operation

Startup / OperationStartup / Operation

Startup / Operation

The hood is to operate via two slide switches. The

lighting as well as the fan settings must be switched

on and off with the corresponding switches.

Power level

Power levelPower level

Power level

0 off I

low

IIII

II medium III

IIIIII

III high

Lighting

LightingLighting

Lighting

0 lighting off I

lighting on

Settings

SettingsSettings

Settings

I Power level

I Power levelI Power level

I Power level:

: :

: Suitable for cooking on a low flame

and for dishes which produce no or little steam, in

order to circulate the air around the kitchen.

II Power level

II Power levelII Power level

II Power level:

: :

: Suitable for normal cooking.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DU 652.1 in the language / languages: English, German as an attachment in your email.

The manual is 0,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bomann DU 652.1 Manual

Product: