652039
19
Zoom out
Zoom in
Previous page
1/28
Next page
19
- Check the operation settings.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the
Reverse the Reverse the
Reverse the door o
door odoor o
door opening
peningpening
pening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:WARNING:
WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply. Always un-
plug the appliance first.
NOTE
NOTENOTE
NOTE:
::
:
When installing, ask another person to assist.
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
From right to left side From left to right side
First dismount the stop plate (A).
Dismount the upper door hinge (2) by loosening
the screws (1). Open the freezer door a little and
take it carefully of the middle door hinge. Place
the door safely aside.
Solve the middle door hinge (4) with the screws
(3). Open the fridge door a little and take it care-
fully of the lower door hinge. Place the door at a
safe place too.
Tilt the appliance slightly backwards and block it
in this position. Dismount the lower door hinge (6)
and the door support device (7).
Attach the door hinge (6) and the door support
device (7) each on the other appliance side, after
you have displaced the hinge pin (5) in the hinge
(6) accordingly.
Replace the appliance upright again. Put on the
fridge door and fix it to the property position.
Turn the middle door hinge (4) about 180° and
transfer it at the opposite side. Put the hinge pin
in the hole of the fridge door and tight the screws
(3).
Put on the freezer door and fix it to the property
position.
Transfer the upper door hinge (2) on the opposite
appliance side. Put the hinge pin in the hole of the
freezer door and tight the screws (1).
Check if the doors are arranged vertically as well
as horizontally, so that a smooth opening and
closing of the doors are ensured.
Install the stop plate (A).
Built
BuiltBuilt
Built-
--
-in
inin
in
Built-in openings
Height x Width x
Depth
1450 x 560-570 x
550 mm
Figures in mm
For the appropriate venting an exhaust duct of
approx. 50 mm depth is to provide at the appliance
back.
The ventilation openings in the furniture base and
building must be min. 200 cm
2
to ensure that heated
air can freely escape.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DTE 338 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DTE 338 in the language / languages: English, German as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info