652481
18
Zoom out
Zoom in
Previous page
1/28
Next page
18
Electr
ElectrElectr
Electrical connection
ical connectionical connection
ical connection
WARNING:
WARNING:WARNING:
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
In case of disconnection or power failure:
- Wait for approx. 5 minutes before restarting.
- Check the operation settings.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the
Reverse the Reverse the
Reverse the door o
door odoor o
door opening
peningpening
pening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:WARNING:
WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply.
NOTE
NOTENOTE
NOTE:
::
:
When installing, ask another person to assist.
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
Remove the cover caps on
the top cover. Loosen the
screws underneath and re-
move the top cover.
Dismount the upper door hinge.
Open the freezer door a little and
lift it out of the middle door hinge.
Place the door safely aside.
Move the screws and the
plastic cap on the opposite
side.
Dismount the middle door hinge.
Open the fridge door a little and
lift it out of the lower door hinge.
Place the door also at a safe place.
Move the cover caps on the
opposite holes.
Tilt the appliance slightly back-
wards and block it in this position.
Unscrew the feet and dismount the door hinge.
Attach the door hinge at the other appliance side,
after you have unscrewed the
hinge pin and used it from the
other hinge side. Turn in the feet accordingly.
Replace the appliance upright. Put on the fridge
door and fix it in its intended position.
Turn the middle door hinge about 180° and trans-
fer it at the opposite side. Put the hinge pin in the
hole of the fridge door and fasten the hinge.
Put on the freezer door and fix it in its intended
position.
Transfer the upper door hinge at the opposite
side, after you have unscrewed
the hinge pin and used it from the
other hinge side. Put the hinge pin in the hole of
the freezer door and fasten the hinge.
Replace the appliance cover, which you have
removed at the beginning. Tight the screws and
clip the screw covers on.
Check if the doors are aligned vertically and hori-
zontally optimally so that the smooth opening and
closing of the doors is guaranteed.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DT 347 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DT 347 in the language / languages: English, German as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info