652480
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
- Gap to the back and to the side walls each
approx. 5 cm;
- Place the appliance so that the appliance door
can open without being impeded.
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter “Technical Data” or to the rating label
located in the interior or on the rear side of the
appliance.
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
Avoid the installation:
Avoid the installation:Avoid the installation:
Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
electric electric
electric
shock
shockshock
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
In case of disconnection or power failure:
- Wait for approx. 5 minutes before restarting.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
- Check the operation settings.
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the
Reverse the Reverse the
Reverse the door o
door odoor o
door opening
peningpening
pening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:WARNING:
WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply first.
NOTE:
NOTE:NOTE:
NOTE:
When installing, ask another person to assist.
You possibly need:
screw wrench, Phillips screw
driver as well as a thin blase screwdriver.
Remove the hinge cover (1).
Loosen the screws (2) under-
neath and remove the upper door
hinge (3). Open the freezer door a little and lift it
out.
Loosen the screw (1) and
transfer the door stopper (2)
to the opposite door underside. Place the door
safely aside.
NOTE:
NOTE:NOTE:
NOTE:
Keep the door stopper for another possible door
stop reversibility.
Dismount the middle door
hinge (2) by loosening the
screws (1). Open the fridge
door a little and lift it out.
Loosen the screw (1) and
transfer the door stopper (2)
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann DT 248 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann DT 248 in the language / languages: English, German as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info