Manual Bomann cb 758 (page 24 of 42) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian)

321855

Zoom out

Zoom in

1/42

ENGLISH

General Safety Instructions

• Read the operating instructions carefully before

putting the appliance into operation and keep the

instructions including the warranty, the receipt and, if

possible, the box with the internal packing.

• The appliance is designed exclusively for private use

and for the envisaged purpose. This appliance is not

ﬁ t for commercial use. Do not use it outdoors (except

if it is designed to be used outdoors). Keep it away

from sources of heat, direct sunlight, humidity (never

dip it into any liquid) and sharp edges. Do not use the

appliance with wet hands. If the appliance is humid or

wet, unplug it immediately. Do not put it in water.

• When cleaning or putting it away, switch off the ap-

pliance and always pull out the plug from the socket

(pull on the plug, not the cable) if the appliance is not

being used and remove the attached accessories.

• Do not operate the machine without supervision. If

you should leave the workplace, always switch the

machine off or remove the plug from the socket (pull

the plug itself, not the lead).

• To protect children from the dangers posed by

electrical appliances, make sure that the cable is

hanging low and that children do not have access to

the appliance.

• Check the appliance and the cable for damage on a

regular basis. Do not use the appliance if it is dama-

ged.

• Do not try to repair the appliance on your own. Always

contact an authorized technician. To avoid the expos-

ure to danger, always have a faulty cable be replaced

only by the manufacturer, by our customer service or

by a qualiﬁ ed person and with a cable of the same

type.

• Use only original spare parts.

• Pay careful attention to the following “Special Safety

Instructions“.

Special Safety Instructions

• Warning! The sole plate, rest (8) and water tank (6)

become hot very quickly and require a long time to

cool down. Please do not touch it.

• When not in use the iron should be stored in the

storage space.

• Before ﬁ lling the water tank with water, remove the

mains plug. Do not ﬁ ll more than 0,7 litre of cold water

into the water tank.

• Do not bend the connecting hose (4)!

• Only clothes are to be ironed with this machine!

• Please use only distilled water. Do not use any decal-

ciﬁ cation agents! These will destroy the machine!

• Symbols on the device!

Note!

Please read the accompanying documents!

Overview of the Components

1 Temperature control

2 Steam jet button with control lamp

3 Fixing device

4 Connecting tube

5 Control lamp steam

6 Water tank

7 Lock/Filling aperture for the water tank

8 Iron well

9 Steam control

10 Operating switch I

11 Operating switch II

12 Pressure indicator

First Use of the Machine

• Clean the ironing base with a slightly damp cloth.

Remove any foil from the sole of the iron.

• In order to remove all residues before initial use, ple-

ase pass the iron a few times over an old clean cloth.

• Open the seal (7) of the water tank and ﬁ ll it through

the opening with not more than 0.7 litres of pure

distilled water. Then re-tighten the seal.

• Do not ﬁ ll battery water, water from the clothes dryer

and water containing additives (such as starch,

perfume, softener or other chemicals) into the water

reservoir. This could damage the iron due to residues

forming in the steam chamber. These residues may

cause impurities to the fabric when dropping out of

the holes in the soleplate.

Connected Wattage

The station has a total maximum wattage of 2600 W. With

this connected load a separate supply line protected by a

16 A household circuit breaker is recommended.

Warning - Danger of Overload!

Do not use any extension leads or multiple sockets

as this device is too powerful.

Using the Machine

Ironing without steam

1. Sort out the garments according to their ironing tem-

peratures.

2. Always turn the temperature control to the lowest

temperature setting before connecting the device to or

disconnecting it from the mains.

3. Start with the lower temperatures. It is set with the

thermostat (1):

• Synthetics, silk low temperature

• • Wool medium temperature

• • • Cotton, linen high temperature

4. Place the iron on its stand.

5. Electrical connection:

• Make sure that the iron voltage (see name plate)

and the line voltage match.

• Only connect the machine to a properly installed

safety socket, 230 V/50 Hz.

6. Turn operating switch I

on the station to position I

and move the steam regulator (9) to MIN. Operating

switch I

lights up. Please ensure that operating

switch II

is turned to position 0.

05-DBS 758 CB_A5 24 02.11.2005, 14:35:20 Uhr

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bomann cb 758 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 1,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bomann cb 758 Manual

Product: