318706

Bomann bs 984 cb Manual

32
Zoom out
Zoom in
Previous page
1/54
Next page
ENGLISH
ENGLISH
32
Adjusting the Height of the Floor Nozzle
Select a setting between fl oor coverings with:
high
pile
medium pile smooth fl oor
Electrical Connection
• Unwind the required cable length and insert the mains plug
into a standard 230 Volt, 50 Hertz wall socket.
ޥ NOTE:
The holders for the cord take-up can be turned through 180°
so that you can take off the cord faster.
Position in Use
• Place your foot on the
unlocking button (1) to
move the handle into the
required position.
• Switch the device on with
the on/off switch (10).
Instructions for Use
ޥ NOTE:
Now you should vacuum at an even speed. Pressing hard is
not necessary.
CAUTION:
Pay attention to the restricted range due to the length of the
cable!
Avoid damaging the surface being cleaned:
• Do not set the brushes too low!
• Do not allow the machine to remain stationary when
switched on!
Switching off
• Move the handle to a vertical position.
• Switch the device off using the on/off switch.
• Remove the plug connector from the plug socket.
• Use the cable take-up to stow away the cable.
Filter
Your machine has three fi lter systems.
1. Transparent dust collection container
The traditional dust bag system has been replaced by a
transparent dust collection container in which coarse dirt
particles and tiny particles fl oating in the air are swirled out
of the suction air by the high speed of the air current.
The quantity of dust can be easily read off at any time on
the container, which is also very easy to empty.
The purchase of dust bags is no longer necessary.
2. Main Filter, Pre-fi lter (in the Dust Container)
WARNING:
Before removing and cleaning the fi lters switch the device
off and remove the plug from the socket.
Once the dust level has reached the MAX mark of the dust
container, please proceed as follows:
1. Press the button (3).
2. Remove the dust container.
3. Empty the contents of the dust container into a suitable
receptacle by pressing button on the dust container.
(See illustration a.)
ޥ NOTE:
Every third time that the fi lters are emptied, or in the
case of severe soiling, clean the fi lters by allowing wa-
ter to fl ow through them against the direction in which
the air blows. The fi lters should only be re-inserted
when they are completely dry!
4. To do so, release the lid with the main fi lter (b).
ޥ NOTE:
By means of short turns in a clockwise or
anticlockwise direction the following components can
be removed or separated.
5. Remove the main fi lter (c). This fi lter can also be
cleaned from time to time with the brush.
6. Remove the pre-fi lter (d). These components can be
separated once more (e).
7. When the components have been cleaned and dried
they can be reinstalled. Connect the components again
by short turns in a clockwise or anticlockwise direction.
3. Motor Protection Filter
Clean the fi lter felt on the bottom of the dust housing every
time you empty the vacuum.
ޥ NOTE:
Every third time that the fi lters are emptied, or in the case
of severe soiling, clean the fi lters by allowing water to
fl ow through them against the direction in which the air
blows. The fi lters should only be re-inserted when they are
completely dry!
05-BS 984 CB 32 15.02.2007, 15:27:19 Uhr
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann bs 984 cb at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann bs 984 cb in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info