814745
11
Zoom out
Zoom in
Previous page
1/58
Next page
BS6058CB_IM_02.2023 16.02.23
11
The latches on the appliance must be in the recesses
of the motor housing. Press the motor housing onto the
collection container until the latches engage.
Connect and Disconnect the Hose
Suction Function
Insert the hose connection into the suction opening on the
collection container. Pay attention to the recesses. Turn the
hose clockwise to tighten.
Fan Function
Insert the hose connection into the blow-out opening on the
motor housing. Pay attention to the recesses. Turn the hose
clockwise to tighten it.
Loosen the Hose
Loosen the hose by turning it anticlockwise and pulling it out.
3-part Suction Tube
Insert the two suction pipes into each other without the
holder.
Insert the thinner end of the assembled suction tubes
into the thicker end of the suction tube with holder.
To detach the suction tubes, pull them off while turning
them slightly.
Nozzle Attachments
To detach the nozzle attachments, pull them off with a
slight twist.
There are several ways to store the brush nozzle and
crevice nozzle.
- Use the holders above the rollers or the holders on
the lid.
Floor Nozzle
You can clean smooth surfaces and carpets dry or wet with
the oor nozzle. The oor nozzle is equipped with rollers for
easier guidance.
Use the lever to move the brushes outwards or inwards.
The optimal use depends on the condition of the oor. We
recommend the following use:
Use without Brushes ( ):
- For vacuuming dry carpets (high pile).
- For cleaning wet, smooth oors.
This setting is also best suited for picking up water
from larger areas.
Note that the collection container can only hold a
limited amount of liquid! The maximum lling quantity
is reduced accordingly for foam-forming additives!
Use with Brushes ( ):
- For vacuuming dry, smooth oors and dry carpets
(low pile).
- For cleaning (scrubbing) wet, smooth oors and wet
carpets (low pile).
Crevice Nozzle
For vacuuming in corners and slits, etc.
Brush Nozzle
For cleaning upholstery or curtains.
Air Slider
Open the air slider on the hose handle to regulate the air or
to loosen parts sticking to the nozzle.
Mains Cable
For operation, unwind the mains cable completely.
After operation, let the motor housing cool down rst. You
can then wrap the mains cable around the motor housing.
Switching On / Off
Use the on / off switch to turn the appliance on (I) and off (O).
Using the Appliance
Preparation
1. Select the desired accessory.
2. Unwind the mains cable completely.
3. Check that the mains voltage you want to use corre-
sponds to the information on the rating plate.
Vacuuming Dry
1. Place the permanent lter in the collection container.
2. Place the motor housing with the recesses on the latches
until they click into place.
3. Fit the accessories.
4. Insert the mains plug into a properly installed earthed
socket.
5. Switch on the appliance.
6. Now vacuum at a steady speed. It is not necessary to
press down.
Wet Vacuuming
1. Pull the mains plug out of the socket.
2. Remove the permanent lter. Insert the sealing ring
instead.
3. Fit the sealing ring over the edge of the collection unit.
4. Place the motor housing with the recesses on the latches
until they click into place.
5. Fit the accessories.
6. Insert the mains plug into a properly installed earthed
socket.
7. Switch on the appliance.
The collection container can only hold a limited amount
of liquid! If foam forms in the collection container, the
maximum collection volume is reduced accordingly!
When the container is full, the oat valve closes the
suction opening and the motor runs at increased speed.
Switch off and empty the appliance immediately.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann BS 6058 CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann BS 6058 CB in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info