687950

Bomann AE 1028 Manual

32
Zoom out
Zoom in
Previous page
1/62
Next page
32
Description of the Parts
1 Tamper
2 Filler opening
3 Transparent cover
4 Safety interlock
5 Centrifuge casing
6 Pomace container
7 On/ Off switch
8 Indicator lamp
9 Juice container with scale
10 Markings for correct installation of the transparent cover
Setting up of the appliance
1. Set the device so that the switch points towards you.
2. Set the centrifuge casing (5) onto the base unit. The open-
ing of the centrifuge casing must be located on the right
side.
3.
WARNING risk of cuts!
The centrifugal sieve is sharp!
Insert the centrifuge sieve. Press it onto the drive wheel
until it clicks into place. Check, whether the centrifuge sieve
can be turned easily. If the sieve were to “drag”, adjust it
again until it can be turned freely and easily.
4. Check the centrifugal sieve! Feel under the sieve edge. It
should not loosen under slight tension.
5. Set the transparent cover (3). The marking (10) on the
cover has to point forward.
6. Insert the juice container with the scale on the left side.
Insert the pomace container on the right side.
7. Close both safety interlocks (4). Ensure that the locking
pins engage in the notches on the cover.
NOTE:
Your appliance is equipped with a safety switch. It
prevents accidental motor start. Check the correct attach-
ment of all components, centrifugal sieve and transparent
cover.
8. Ensure that the On/ Off switch (7) is set to “OFF”.
Electric Connection
• Before inserting the power plug into the outlet, check that
the mains voltage to be used matches that of the device.
You can nd the required information on the nameplate.
• Connect the device only to a correctly installed safety
socket.
Operation
Preparations
• Wash the fruit to be processed.
• Cut the fruit in pieces to t through the ller opening.
• Remove large pips and stems.
Extracting Juice
NOTE:
The appliance is intended for short-term use. After operating
it for 1 minute, take a 5 minute break.
WARNING:
Check all accessories again for proper attachment before
switching the appliance on.
1. Set the On/Off switch to the “ON” position. The indicator
lamp (8) will be lit and the motor will start.
2. Insert the fruit pieces in the ller opening and push them
down with the tamper. Please note! The tamper has a
guide way in the ller opening.
3. The juice will now ow into the juice container. The pulp is
collected in the pulp container.
NOTE:
• Observe the juice jug. Stop operation in time to prevent
overowing. The lling quantity of 500 ml should not be
exceeded.
• Berries and citrus fruits (such as gooseberries, grapes,
oranges) are usually not juiced but pressed.
• When juicing these fruits with their high juice content,
splashing of juice from the area of the pomace container
may occur. In this case, we recommend that the pomace
container is emptied more frequently.
Stop Operation And Disassembly
1. Set the On/ Off switch to “OFF” and wait until the centrifuge
sieve has come to a standstill.
2. Disconnect from mains power supply.
3. Open the safety interlocks.
4. Remove the juice and the pomace container.
5. Remove the transparent cover.
6. Remove the centrifugal sieve with the centrifuge casing.
Use both hands to lift the centrifuge casing up.
WARNING risk of cuts!
The centrifugal sieve has sharp knives!
Only lift it on its outer edge.
7. Lift the centrifugal sieve out of the centrifuge casing.
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann AE 1028 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann AE 1028 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 6,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info