573569
50
Zoom out
Zoom in
Previous page
1/52
Next page
48
T
T
R
R
O
O
U
U
B
B
L
L
E
E
S
S
H
H
O
O
O
O
T
T
I
I
N
N
G
G
G
G
U
U
I
I
D
D
E
E
CODE REASON SOLUTION
E1
Message failure between
computer and bottom control
board
1. Check the computer and bottom
control board wire connect well.
2. Check if IC on bottom control board
is loosen, reset the IC.
3. Power on bottom control board has
some problem, change the bottom
control board.
E2
Burst clash 1. Check the power is right, if not, use
correct power to test.
2. Check if the bottom control was
burnt out, change a good one;
reconnect the motor wire.
E3
No sensor signal
1 Check the speed sensor wire
connect well, reconnect the wire.
2 Check if the speed sensor was
damaged, change a good one.
E4
Incline Error 1. Check the incline motor wire
connect well, reconnect the wire.
2. Check if the incline motor was
damaged, change a good one.
E5
Current overload protecting
1 Over rated loaded or the motor is
stuck, cause excessive current,
machine will start self-protecting
system. Adjust the machine and
restart.
2 Check if the motor has noise from
motor or if the motor / bottom
control board were burnt out, if
burnt out, change good motor and
bottom control; Use right voltage.
E8
Driver Problem
1 Check if the 24C02 8 pin IC in the
bottom control board connect well,
reconnect it.
2 Change the bottom control board
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BodySculpture BT-5405 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BodySculpture BT-5405 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info