518709

BodyCraft Strata Legpress Type 2 Manual

9
Zoom out
Zoom in
Previous page
1/22
Next page
6
STEP2
5
1
2
4
81
8
80
72
82
38
38
59
58
65
75
75
77
74
8
3
5
2
7
45
4
1
41
70
70
76
41
9
1.Slide STACK SPACERS(7), RUBBER CUSHIONS(45) onto GUIDE RODS(8)
and insert into holes in LEFT WEIGHT BASE(2) as shown.
2.Slide WEIGHT PLATE(81) onto GUIDE ROD(8) as shown. Assemble TOP PLATE(82)
to SELECTOR ROD(80) using the TOP PLATE BOLT(72), Slide TOP PLATE(82)
onto GUIDE RODS(8) and inserting SELECTOR ROD(80) into center hole of WEIGHT
PLATES(81).
Visually check to make certain GUIDE ROD(8) are fully seated in top in top
and bottom holes. All WEIGHT PLATES(81) are facing the proper direction and
STACK SPACER(7), RUBBER CUSHION(45) are installed properly.
3.Place TOP BEAM(9) over the top of GUIDE ROD(8) and attach to REAR SUPPORT(3)
AGAIN DO NOT TIGHTEN UNTIL ALL COMPLETED using one 1/2" x 4" HEX HEAD
BOLT(59), one 1/2" x 4-1/2" HEX HEAD BOLT(58) three 1/2" WASHER(74) and one 1/2"
NYLON NUT(76) and to FRONT SUPPORT(5) using two 3/8" x 2-3/4" HEX HEAD BOLT,
four 3/8" WASHER(75) and two 3/8" NYLON NUT(77).
4.Tighten all bolts. Except connection of part 5 and 9, hand tighten only.
Make sure frame connections are very secure.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BodyCraft Strata Legpress Type 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BodyCraft Strata Legpress Type 2 in the language / languages: English as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info