Manual Bobike Go Maxi - 1 (page 7 of 106) (All languages)

772929

Zoom out

Zoom in

1/106

• The rider must be at least 16 years of age; Check legislation and national regulations

pertaining to this.

• Make sure that the weight and height of the child do not exceed the maximum

capacity of the seat, and check this at regular intervals. Check the weight of the child

before using the child seat. Under no circumstances should you use the child bicycle

seat to transport a child whose weight is above the permissible limit.

• Do not carry a child less than 9 months of age in this child bicycle seat. To be a passenger,

the child must be able to sit up straight with the head held upright while wearing a

bicycle helmet. A doctor should be consulted if the child’s growth is questionable.

• Secure the child into child bicycle seat ensuring that all the safety belts and straps

applied ﬁrmly but not so tight as to cause discomfort to the child. Please check the

safety of the fasteners often.

• The child bicycle seat must never be used before adjusting the safety belt.

• Always use all safety restraint system and straps to ensure that the child is secured in

the seat.

• Do not allow any part of the child’s body or clothing, shoelaces, child bicycle seat belts,

etc. to come in contact with moving parts of the bicycle because can be harmful to the

child or cause accidents.

• A wheel protector is recommended to prevent the child from inserting its feet or

hands between the spokes. The use of protection underneath the saddle or the use

of a saddle with internal springs is mandatory. Make certain that the child is not able to

Detach the safety-belt (C) in order to remove the child seat. To remove the seat from the

luggage carrier, unfasten the hand knob (G1) and lift simultaneously the security ring

(G2) in order to open the jaw (G3) wider than the width of the luggage carrier.

INSTRUCTIONS FOR USE

HOW TO REMOVE YOUR BICYCLE SEAT

must not exceed 10 cm. If the centre of gravity is more than this distance from the axle,

adjust the seat to the correct position. Special care must also be taken when positioning

the child seat to ensure that the cyclist does not touch the child seat with his feet when

cycling. Make sure that the mounting plate (G) is ﬁrmly attached to the carrier before

proceeding. This step is extremely important for child and cyclist safety. Check the

safety of the fasteners regularly.

Note: In Germany, according to the German Traﬃc Law StVZO, bicycle seats may only be

ﬁxed so that 2/3 of the seat depth or the Gravity Center of the seat is located between

the front and rear axle of the bicycle.

5. Pass the safety belt (C) around the bicycle frame. Adjust it as shown in the picture,

under tension. Make sure that remain loosen belt is not in contact with the wheel. This

step is extremely important for the child’s safety.

6. To place the child in the seat, ﬁrst open the belt.

Start by pressing the releases on the sides of the safety buckle (B4) and pull the buckle

(B1) upwards, so that it slides out of the socket (B5).

Place the child in the seat. Insert the safety buckle (B1) in its socket again (B5). Make sure

that the buckle socket (B5) is correctly positioned and does not hurt the child.

Next, adjust the belt to the size of the child to ensure that the child is ﬁrmly secured. First

adjust the height of the belt. To do this, pull the straps according to the size of the child,

adjusting the (B2) and (B3) belt adjusters.

According to the child growth you can adjust the height of the belt on the available

holes for belt adjustment (B6).

Before starting the journey, always check that the child is secured and that the belt is

snug but not so tight that it hurts the child. We recommend that the child’s helmet be

put on after the belt is adjusted.

Note: Always use the restraint system.

7. Adjust the height of the footrest according to the size of the child. To do this, raise the

lever (E1) and slide it up or down for the required height. After deciding on the correct

height, lower the lever (E1) to lock in place.

8. To remove the footrest strap (D), lift it slightly to release it from the footrest peg (E2)

and slide it upwards to disengage it from the footrest slot. Then pass the thin end of the

plastic strap through the hole in the footrest, as shown in the picture. Once the strap is

correctly positioned, it can be easily slid up or down according to the child’s foot. Next

slot one of the openings in the strap over the foot support peg. If you want to remove

the strap (D), twist it slightly to loosen it from the foot support peg (E2).

9. Make sure you have followed and fulﬁlled all the instructions given. When done so,

the child bicycle seat is ready for use. IT IS MANDATORY TO READ the following

chapter on safety instructions about using your child bicycle seat.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bobike Go Maxi - 1 in the language / languages: All languages as an attachment in your email.

The manual is 2.39 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bobike Go Maxi - 1 Manual

Product: