706483
15
Zoom out
Zoom in
Previous page
1/47
Next page
Gas Requirements & Checking For Leaks
Small deviations may occur. This is not related to quality but subject to improvements.
The appliance must only be powered with LPG gas less than 15-kg cylinder.
The regulator must be EN12864 approved and the hose must be EN1763-1 approved
with a length less than 50 cm.
Connect one end of the hose to the pressure regulator and the other end of the hose
to the tap. Make sure that the connections are tight and there is no damage to any
component or tting.
Before connecting the cylinder, make sure that its tap is closed and there are no open
ames (lit oven, etc.) in the vicinity and the gasket seal is in good condition. Then screw
the pressure regulator onto the cylinder.
Attach the regulator to the tap, screw the nut tightly counterclockwise.
Carefully check that there is no gas leaking from the connection using soapy water (one
part detergent and three parts water). If there is a leak, bubbles will form; tighten the
connection more or seek professionally qualied service.
Place the cylinder in its compartment, taking care that the tube is not twisted or choked
and doesn’t touch any hot parts.
Align the rear cylinder cover onto the main body, see ASSEMBLY 2.
To replace the cylinder, make sure that its tap is closed and that there are no open ames
(lit oven, etc.) or sources of heat in the place where you are working.
The hose used for this appliance must be replaced every two years.
Check the gas hose once per month and each time the cylinder is changed, if it shows
cracking, splitting or other deterioration, it should be replaced with a new one.
To not mishandle the connections or other components.
Do not turn the cylinder upside down to completely use its contents: this releases liquid
residues left in the tank that will irreparably damage the heater.
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blumfeldt Bonaparte Catalyt - 10032818 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blumfeldt Bonaparte Catalyt - 10032818 in the language / languages: English, German as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info