778084

Blumfeldt 10035958 Heatwave Manual

25
Zoom out
Zoom in
Previous page
1/84
Next page
25
EN
Step 5
Attach the wheels to the bottom of the unit base with 2 screws (M6x12) and
washers (ignore this step if the wheel set is already pre-installed).
GAS REQUIREMENTS
• A standard gas pressure regulator according to EN16129 and a standard
gas hose according to EN16436-1 with a length of at least 0.5 metres must
be used for the unit.
• Never use a gas cylinder with a damaged housing, valve, sleeve or foot ring.
A damaged or rusted gas cylinder can be dangerous and should be checked
by a gas cylinder dealer.
• Never connect this appliance to an unregulated gas source.
• Turn off the gas bottle when the appliance is not in use.
• When connecting a gas cylinder, always carry out a leak test on all
connections. If bubbles form during the leak test, do not use the appliance
under any circumstances. Never test for leaks with an open ame.
CONNECTION TO A GAS BOTTLE
• Follow the operating instructions for the gas bottle.
• Only change gas cylinders outdoors or in well-ventilated areas at a safe
distance from ignition sources.
• The gas bottle must be in an upright position at all times.
• Turn the control knob of the heater to the “OFF” position by turning it fully
clockwise.
• Close the gas bottle valve and attach the gas pressure regulator to the gas
bottle.
• Tighten all connections rmly, using an open-ended spanner if necessary.
The gas bottle should be on the gas bottle base.
• Check all connections for leaks with a soap solution. If there is a leak,
tighten the connector where the leak occurred and perform the test again.
• When installing the gas cylinder in the device housing, it must be fastened
with the straps located in the device housing.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blumfeldt 10035958 Heatwave at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blumfeldt 10035958 Heatwave in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 2.03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info