778063

Blumfeldt 10033811 Dark Wave Stand Manual

21
Zoom out
Zoom in
Previous page
1/64
Next page
21
EN
The following numbers refer to the numbering indicated in the scope of
delivery.
1. Place the 4 x feet (5) into the slots on the bottom of the base of the pole
(2).
2. Tighten pole (2) into the stand centre by turning the pre-attached stand
centre cover clockwise until tight.
3. Place the heater head (1) face down on a soft surface. Attach the 2 x
brackets(3) to the plates in the back of the heater (1) using 4 x bolts (A). Do
not over tighten at this stage so the brackets can easily slide in the groove
on the back of the heater head (1). English head (1) is lined up centrally.
4. Using the 2 x cogs (4) and 2 x washers (B) attach the heater head (1) to the
pole, adjust the brackets (3) and angle of the heater head (1) to position to
your desired angle and tighten the cogs (4).Tighten 4 x bolts (A) to secure.
5. Secure the cable to the pole (2) using the pre-attached cable clips.
The heater is now ready to use. Please see operation instruction. Ensure you
have read these instructions thoroughly prior to use.
Wall mounting
1. There are 4 brackets and fasteners used with the heater. Furthermore, in
the canal of back side of the heater there are 4 square fastener washers
25×25mm. Take the square washers(Figure 1)and fasten 2 brackets to the
canal of the backside of the heater by the help of screws(Figure 2) .
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blumfeldt 10033811 Dark Wave Stand at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blumfeldt 10033811 Dark Wave Stand in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info