477859
7
Zoom out
Zoom in
Previous page
1/17
Next page
CONNECTIONS
(MA200-MA400)
.Parallel
(Mono) Mode
To
put
the
amplifier
in
parallel-mono
mode,
firs!
turn
the
amplifier off, then
slide
the
MODE
SELECTOR
SWITCH
(15)
to the top
"PARALLEL
(MONO)"
position
and
properly connect
the
input/output
wiring
as
shown.
A
signal
into
any
input
connector
will
drive both
channels directly.
You can
patch
the
input signal
on to any
other amps using
any of the
remaining input jacks.
(Note-
Do
not
connect
a
speaker load less than
4
ohms
as it can
damage
your
amplifier.)
[Note:
Do not use the
"PARALLEL
(MONO)"
switch when feeding
the amp 2
separate
signals.
.
Bridged Mono Mode
To
put the
amplifier
in
bridged mono mode, turn
the
amplifier
off and
slide
the
MODE SELECTOR SWITCH
(15)
toward
the
bottom
"BRIDGED"
position
and
properly connect
the
input/output
wiring
as
shown.
The
signal
is
input
into
CH-1.
Keep
the
level control
of
channel
"2"
turned
completely down (counter
clock
wise).
(Note:
Do
(Note: This
nnect
mode
produces
a'ker
load
of
less
than
4
oh
lage
your amplifier.)
e
that your wiring
and
speaker
ca
PageS
Reference Manual
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bluetech MA series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bluetech MA series in the language / languages: English as an attachment in your email.

The manual is 4,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info