491457
53
Zoom out
Zoom in
Previous page
1/76
Next page
53
EN
7 Troubleshooting
Programmecannotbestartedorselected.
Washingmachinehasswitchedtoselfprotectionmodeduetoasupplyproblem(linevoltage,waterpressure,etc.).>>>Press
and hold Start / Pause button for 3 seconds to reset the machine to factory settings. (See Canceling the programme”)
Water in the machine.
Somewatermighthaveremainedintheproductduetothequalitycontrolprocessesintheproduction.>>>This is not a
failure; water is not harmful to the machine.
Machinevibratesormakesnoise.
Machinemightbestandingunbalanced.>>>Adjust the feet to level the machine.
Ahardsubstancemighthaveenteredintothepumpfilter.>>>Clean the pump filter.
Transportationsafetyboltsarenotremoved.>>>Remove the transportation safety bolts.
Laundryquantityinthemachinemightbetoolittle.>>>Add more laundry to the machine.
Machinemightbeoverloadedwithlaundry.>>>Take out some of the laundry from the machine or distribute the load by
hand to balance it homogenously in the machine.
Machinemightbeleaningonarigiditem.>>>Make sure that the machine is not leaning on anything.
Machinestoppedshortlyaftertheprogrammestarted.
Machinemighthavestoppedtemporarilyduetolowvoltage.>>>It will resume running when the voltage restores to the
normal level.
Programmetimedoesnotcountdown.(Onmodelswithdisplay)
Timermaystopduringwaterintake.>>>Timer indicator will not countdown until the machine takes in adequate amount of
water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
Timermaystopduringheatingstep.>>>Timer indicator will not countdown until the machine reaches the selected
temperature.
Timermaystopduringspinningstep.>>>Automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the drum.
C
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the
machine and to its surrounding environment. Laundry should be rearranged and re-spun.
Foamisoverflowingfromthedetergentdrawer.
Toomuchdetergentisused.>>>Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of
the detergent drawer.
C
Putdetergentintothemachinesuitablefortheprogrammesandmaximumloadsindicatedinthe“Programmeand
consumptiontable”.Whenyouuseadditionalchemicals(stainremovers,bleachsandetc),reducetheamountofdetergent.
Laundryremainswetattheendoftheprogramme
Excessivefoammighthaveoccurredandautomaticfoamabsorptionsystemmighthavebeenactivatedduetotoomuch
detergentusage.>>>Use recommended amount of detergent.
C
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the
machine and to its surrounding environment. Laundry should be rearranged and re-spun.
A
Ifyoucannoteliminatetheproblemalthoughyoufollowtheinstructionsinthissection,consultyourdealerortheAuthorized
ServiceAgent.Nevertrytorepairanonfunctionalproductyourself.
2820522851_EN/280312.1624
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg WNF 8447 ACE 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg WNF 8447 ACE 50 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info