Manual Blomberg wnf 7341 a (page 4 of 68) (English, German, Italian)

315452

Zoom out

Zoom in

1/68

• Topreventflowingofdirtywaterbackintothe

machine and to allow for easy discharge, do

not immerse the hose end into the dirty water or

driveitinthedrainmorethan15cm.Ifitistoo

long, cut it short.

• Theendofthehoseshouldnotbebent,it

shouldnotbesteppedonandthehosemust

notbepinchedbetweenthedrainandthe

machine.

• Ifthelengthofthehoseistooshort,useitby

adding an original extension hose. Length of the

hosemaynotbelongerthan3.2m.Toavoid

waterleakfailures,theconnectionbetween

the extension hose and the drain hose of the

productmustbefittedwellwithanappropriate

clamp as not to come off and leak.

Adjusting the feet

 Inordertoensurethattheproductoperates

moresilentandvibration-free,itmuststandlevel

andbalancedonitsfeet.Balancethemachine

byadjustingthefeet.Otherwise,theproduct

may move from its place and cause crushing

andvibrationproblems.

1. Loosenthelocknutsonthefeetbyhand.

2. Adjust the feet until the product stands level and

balanced.

3. Tightenalllocknutsagainbyhand.

 Donotuseanytoolstoloosenthelocknuts.

Otherwise,theywillgetdamaged.

Electrical connection

Connect the product to a grounded outlet protected

byafusecomplyingwiththevaluesinthe"Technical

specifications"table.Ourcompanyshallnotbeliable

for any damages that will arise when the product is

used without grounding in accordance with the local

regulations.

• Connectionmustcomplywithnational

regulations.

• Powercableplugmustbewithineasyreach

after installation.

• Thevoltageandallowedfuseorbreaker

protection are specified in the “Technical

specifications”section.Ifthecurrentvalueof

thefuseorbreakerinthehouseislessthan16

Amps,haveaqualifiedelectricianinstalla16

Amp fuse.

• Thespecifiedvoltagemustbeequaltoyour

mains voltage.

• Donotmakeconnectionsviaextensioncables

ormulti-plugs.

 Damagedpowercablesmustbereplacedby

the Authorized Service Agents.

First use

Beforestartingtousetheproduct,makesure

that all preparations are made in accordance

withtheinstructionsinsections"Importantsafety

instructions"and"Installation".

To prepare the product for washing laundry, perform

firstoperationinDrumCleaningprogramme.If

yourmachineisnotfeaturedwithDrumCleaning

programme,useCottons-90programmeandselect

Additional Water or Extra Rinse auxiliary functions

aswell.Beforestartingtheprogramme,putmax.

100gofpowderanti-limescaleintothemainwash

detergentcompartment(compartmentnr.II).Ifthe

anti-limescaleisintabletform,putonlyonetablet

intocompartmentnr.II.Drytheinsideofthebellow

with a clean piece of cloth after the programme has

come to an end.

 Useananti-limescalesuitableforthewashing

machines.

Some water might have remained in the

productduetothequalitycontrolprocessesin

How to replace the door seal on WNF7341a washing machine please. Submitted on 3-3-2021 at 12:35
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg wnf 7341 a in the language / languages: English, German, Italian as an attachment in your email.

The manual is 3,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Blomberg wnf 7341 a Manual

Product: