640549

Blomberg WM 67120 NBL00 Manual

9
Zoom out
Zoom in
Previous page
1/40
Next page
9 EN
Read this first !
This washer can be individually installed
in free-standing and built-in installations.
You can also install your washer with
your dryer as a free-standing or built-in
pair. Before you install your appliance,
read the following instructions
completely and carefully:
• Savetheseinstructionsforfuture
reference.
• Thisappliancemustbeproperly
installed and grounded by qualified
and skilled technicians in accordance
with all local codes and ordinances
and the latest edition of the National
ElectricalCode,ANSI/NFPA70.
• Properinstallationofthisappliance
is the responsibility of the owner and
failure due to improper installation is
not covered by the warranty.
The Right Location of
Installation
You can install your washer in a
basement, closet or in a laundry room
if the location has proper drainage,
plumbing and power supply system.
Always follow these instructions for
installation:
• Donotinstallorstorethisappliance
where it will be exposed to the
weather, rain, damp places, water
and direct sunlight. The ambient
temperature must be higher than
60°F (15.6°C) for proper operation.
Installation location must have the
proper ventilation.
• Donotstoreanduseanyflammable
and combustible substances such
as lint, paper, curtains, gasoline, coal
and liquid or vapor chemicals near
the appliance.
• Installandoperatethewasherona
strong solid concrete floor to prevent
vibration, noise or movement in case
of load unbalance. The floor must
have sufficient load carrying capacity
and the washer must be leveled
properly before the operation.
• Itisnotrecommendedtoinstalland
3 Installation Instructions
operate the washer on a wooden
floor or soft floor. If you have to install
your washer on a wooden or frame
construction floor, the floor must be
reinforced properly and the washer
must be located in the corner of the
room if possible.
• Neverplaceyourwasheronacarpet.
This prevents air circulation. The
electrical components of the machine
may overheat and cause damage.
• Donotstandapplianceonthepower
cable.
• Donotinstallandoperateyour
washer in ambient temperatures
lowerthan32˚F(0˚C).Controls
may stop working properly in such
condition.
• Ifthereisdangeroffrost,drain
all remaining water in pump and
hoses since it may freeze and cause
damage by bursting them (see
“Cleaning the drain pump filter”).
Installation Clearances
C
The installation location must be large
enough for the washer door to be
fully opened for loading.
C
The installation location must be
large enough for ease of operation,
maintenance and service.
C
Ensure there is min 1/2” of clearance
on each side of the washer to allow
slight side ways movement during
washing and spin drying.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg WM 67120 NBL00 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg WM 67120 NBL00 in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info