581563
16
Zoom out
Zoom in
Previous page
1/42
Next page
16 - EN
programme. (See. Finishing by canceling
the programme)
Speed and function indicators will turn off when
you change the position of the programme
selection knob while the machine is running
(audio warning, drying level and anti-crease
symbols). However, the current programme
continues. If the programme selection knob is
turned back to the current programme, symbols
of those indicators will appear again.
Adding/removing laundry in standby mode
In order to add or remove laundry after the
programme starts:
1. Press the “Start/Pause/Cancel” button to
switch the dryer to “Pause” mode. Drying
process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to start
the programme.
C Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The
loading door and all buttons except the “On/
Off” button on the control panel are deactivated
when the child-proof lock is active.
In order to activate the childproof lock, press on
the “audio warning” and “anti-creasing” buttons
simultaneously for 3 seconds.
To start a new programme after the programme
is over or to interrupt the programme, the child-
proof lock should be deactivated. Press the
same buttons for 3 sec. again to deactivate the
child-proof lock.
C Lock symbol will appear on the screen
when the child-proof lock is activated.
Finishing by canceling the programme
The programme which is selected first will
keep on running even if the position of the
programme selection knob is changed when
the dryer is operating. A new programme can
be selected and started after “Programme
cancel” is activated in order to change the
drying programme.
To cancel any selected programme:
Press “Start/Pause/Cancel” button for
about 3 seconds. “Filter cleaning” and
“Water tank” warning symbols light up and
“End” label appears on the screen as a
reminder at the end of this period.
A As the inside of the dryer will be excessively
hot when you cancel the programme while
the dryer is running, activate the ventilation
programme to cool it down.
A If the position of the programme selection
knob is changed after stopping the dryer
while it is running at any programme, an
audio warning will be heard since the
running programme is not cancelled (if the
“Cancel audio warning” is not selected).
Dryer will not operate even you press the
“Start/Pause” button unless it is switched
back to the previously running programme.
You must cancel the ongoing programme
in order to change the drying programme.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg TKF 7459 Z at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg TKF 7459 Z in the language / languages: English, German as an attachment in your email.

The manual is 3,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info