• Time up is indicated by an acoustic signal and by “00” on the display, the cooking zone
indicator light for the timer flashes. The cooking zone is switched off, and “H” appears if the
zone is “burning hot”, otherwise a “dash” appears on the cooking zone display.
The sound signal and flashing on the display are interrupted:
• Automatically after 2 minutes.
• By pressing one of the buttons.
The timer display switches off.
• The basic functions are the same as the ones described for the autonomous timer.
Pan recognition function (with dedicated electronics only)
The touch control does not contain pan recognition sensors.
Table:
Display Possible causes Countermeasures
Er12 Short-circuit in the 5V or earthed
control relay
Replace the control
Er16 Short-circuit or disconnected pan
sensor or power supply
Remove the causes (customer service)
Er22 Short-circuit or disconnection in the
pressure button area
Replace the control
Er25 Control incorrectly connected Connect to correct mains voltage
Er26 Short-circuit in the relay tension
control
Replace the control
Continuous
sound
Water on the glass above the control
card
Clean
“H“ flashes Hot pan on the control card; faulty
radiant hotplate seal
Wait until the control card returns to the
normal temperature
Faulty component Replace the control
Er33 Water on the glass above the control
card
Clean
WARNING
Before any operation:
Disconnect the hob from the electrical mains.
Make sure that the hob is cold.
Do not try to repair the hob on your own, contact a qualified service centre.
