638941
16
Zoom out
Zoom in
Previous page
1/26
Next page
16
Disposal
Appliance Packaging Information
All materials are environmentally sound! They can be
dumped or burned at an incinerating plant without
danger!
About the materials: The plastics can be recycled and
are identified as follows:
>PE< for polyethylene, e.g. the outer covering and
the bags in the interior.
>PS< for polystyrene foam, e.g. the pads, which are
all free of chlorofluorocarbon.
The carton parts are made from recycled paper and
should be disposed of at a waste-paper recycling
collection location.
Disposal of old Appliances
For environmental reasons, refrigeration appliances
must be disposed of properly. This applies to your old
appliance, and - at the end of its service life - for your
new appliance as well.
Warning! Before disposing of old appliances
make them inoperable. Remove plug from mains,
sever the power cable, remove or destroy any snap or
latch closures. This eliminates the danger that playing
children lock themselves into the appliance (danger
of suffocation!) or place themselves into other life-
endangering situations.
Disposal:
The appliance may not be disposed of with
domestic waste or bulky refuse.
The refrigerant circuit, especially the heat
exchanger at the back of the appliance, may not
be damaged.
Information concerning collection schedules or
locations can be obtained from the local disposal
authorities or town hall.
The appliance and the interior fittings are protected
for transport.
Pull off the adhesive tape on the left and right
side of the door.
Remove transport safeguard
• Remove all adhesive tape and packing
pieces from the interior of the appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated,
dry room.
Energy use is affected by the ambient temperature.
The appliance should therefore
not be exposed to direct sunlight;
not be installed next to radiators, cookers or
other sources of heat;
only be installed at a location whose ambient
temperature corresponds to the climate classifi-
cation, for which the appliance is designed.
The climate classification can be found on the serial
plate, which is located at the left on the inside of the
appliance.
The following table shows which ambient temperatu-
re is correct for each climate classification: each cli-
mate classification:
Climate classification for an ambient temperature of
SN +10 bis +32 °C
N +16 bis +32 °C
ST +18 bis +38 °C
T +18 bis +43 °C
If installation next to a source of heat is unavoidable,
the following minimum clearances must be maintai-
ned at the sides of the appliance:
– for electric cookers 3 cm;
– for oil and coal fired ranges 30 cm.
If these clearances cannot be maintained a heat insu-
lating pad is required between the cooker and the ref-
rigeration appliance.
If the refrigeration appliance is installed next to ano-
ther refrigerator or freezer a clearance of 5 cm at the
sides is required, in order to prevent the formation of
condensation on the outside of the appliance.
37
Bruits anormaux.
L’appareil est en contact avec la paroi ou
d’autres objets.
L’appareil n’est pas d’aplomb.
Une partie de l’appareil, p. ex. un tuyau, est
en contact avec une autre partie de l’ap-
pareil ou la paroi à l’arrière de l’appareil
Le cas échéant, plier cette partie avec pré-
caution pour l’éloigner.
Déplacer légèrement l’appareil.
Ajuster les pieds réglables.
Le compresseur se met en marche de lui
même au bout d’un certain temps.
Voir section "Nettoyage et Entretien".
Ceci est normal, il ne s’agit pas d’un déran-
gement.
Après modification du réglage de tempéra-
ture, le compresseur ne démarre pas immé-
diatement.
Il y a de l’eau au fond du compartiment sur-
gélateur ou sur les surfaces de rangement.
Le trou d’écoulement de l’eau de dégivrage
est bou-ché.
Remplacement de la lampe
Attention! Danger d'électrocution! Avant de rem-
placer la lampe, débrancher l'appareil et tirer la fiche
de la prise de courant ou débran-cher ou retirer le fusi-
ble. Données de la lampe: 220-240 V, max. 15 W.
1. Pour débrancher l'appareil, tourner le régulateur
de température sur „0".
2. Tirer la fiche de la prise de courant.
3. Pour remplacer la lampe, dévisser la vis.
4. Excer une pression sur le cache de l’ampoule,
comme l’indique la fig., et le faire glisser vers l’ar-
rière.
5. Remplacer la lampe défectueuse.
6. Remonter le cache de l’ampoule et revisser la vis
de fixation.
7. Remettre en marche le réfrigérateur.
D411
L’appareil frigorifique est destiné à un usage dome-
stique et a été fabriqué en respect des normes s’ap-
pliquant à ce type d’appareils. La fabrication tient en
particulier compte des mesures prévues par la loi
allemande sur la sécurité des appareils (GSG), le
règlement préventif contre les accidents pour les
installations frigorifiques (VBG 20) et les dispositions
de l’union des électrotechniciens allemands (VDE).
L’étanchéité du circuit frigorifique a été contrôlée.
Cet appareil est conforme aux directives
européennes suivantes :
– 73/23/CEE du 19.2.1973 - Directive sur les
basses tensions
– 89/336/CEE du 3.5.1989
(y compris la directive de modification 92/31/CEE) -
Directive de CEM
Règlements, normes, directives
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blomberg KFI1290 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blomberg KFI1290 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info