699029

Blaupunkt ISD-SD1 Manual

10
Zoom out
Zoom in
Previous page
1/44
Next page
10
Alarm silence (silence mode)
During the unit is alarming, you push the
test button, it will pause the unit from
alarming for approx 10 minutes. The red LED
will flash once every 8 seconds, it indicates
the smoke alarm device is running on silen-
ce mode, this function is meant to minimize
nuisance alarms. Combustion particles from
cooking may set off the alarm if the alarm is
located close to the cooking area. The alarm
silence (test button) is extremely useful in a
kitchen area or other areas prone to nuisan-
ce alarms. The silence feature is to be used
only when a known alarm condition, such as
smoke from cooking activates the alarm.
The smoke alarm device will automatically
reset after approximately 10 minutes, if after
this period, particles of combustion are still
present, the alarm will sound again.
The alarm silencer (silence mode) can be
repeatedly until the air has been cleared of
the condition causing the alarm.
CAUTION: Before using the alarm silence
(silence), identify the source of the smoke
and be certain a safe condition exists.
DANGER: If the alarm sounds, and it is not
being tested, it means the unit is sensing
smoke, THE SOUND OF THE ALARM
REQUIRES YOUR IMMEDIATE ATTENTION
AND ACTION.
Maintenance and Cleaning:
In addition to weekly testing, the alarm
requires periodic cleaning to remove dust,
dirt, and debris.
Clean the alarm at least once a month to
remove dust, dirt, or debris. Use a vacuum
cleaner with the soft brush, vacuum all sides
and covers of smoke alarm device. Hint. If
the Detector is installed with a magnetic
plate, the removing and cleaning can be
a lot easier.
This alarm has a low battery monitor which
will cause the alarm to “chirp” approx every
40 seconds and the red LED flash once at
the same time for a minimum of thirty days
when the battery gets low. If there is a de-
fective battery or other failures, you can refer
to “Trouble shooting” for solution, if there are
still failures during warranty, you can return
to your retailer.
WARNING: The battery is sealed in cover
and not replaceable. Please replace
another new alarm if the low battery chirp
occurs.
IMPORTANT: Do not attempt to remove
the cover to clean inside. This will affect
warranty.
Repair:
Caution: Do not attempt to repair the alarm.
It will affect
your warranty. If the alarm is not operating
properly, and is still under warranty, return
it to the original place you buy. Pack it in a
well-padded carton, and ship to the original
place you buy. If the alarm is no longer
under warranty, have a licensed electrician
replace it immediately with a comparable
alarm.
Trouble shooting:
Problem Method of disposal
Smoke alarm
device does
not sound
when tested.
1. Fit the alarm on the
bracket and turn the
alarm body clockwise,
until matching well.
2. Clean smoke alarm
device. Please refer to
the “maintenance and
cleaning” section.
3. If there are still failures
during warranty, you can
return to your retailer.
4. If the unit is out of
warranty, please replace
another new alarm.
The alarm
“chirp” with red
LED flashes
once every 40
seconds.
The battery is under low
battery status, please
replace the smoke alarm
device.
Smoke alarm
device chirp
occurs every
40 seconds
(alarm goes
into fault
mode).
Clean smoke alarm
device. Please refer to
the “maintenance and
cleaning” section. Purcha-
se and change another
smoke alarm device if the
problem still exist
Smoke alarm
device sounds
unwanted
alarms inter-
mittently or
when residents
are cooking,
taking showers,
etc.
1. Press test button to
pause alarm.
2. Clean smoke alarm
device. Please refer to
the “maintenance and
cleaning” section.
3. Move smoke alarm
device to new location
and press test button.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt ISD-SD1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt ISD-SD1 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 8,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info