460817
46
Zoom out
Zoom in
Previous page
1/52
Next page
GTA 4 Special Edition 2011
46
When selecting the installation location, select a dry loca-
tion that offers sufficient air circulation for cooling the
ampli er.
The GTA 4 Special must not be installed on rear shelves, rear
seats or other locations that are open to the front.
The installation location must be suitable to accept the ac-
companying screws and provide a  rm support.
The ampli er power cable must be  tted with a fuse no more
than 30 cm from the battery to protect the vehicle battery in
case of a short circuit between power ampli er and battery.
The fuse of the ampli er protects only the ampli er, not the
vehicle battery.
Use loudspeakers with 2 - 4  impedance (see table or in-
stallation drawing). Observe the maximum power handling
capacity (music output). Do not connect loudspeakers to
earth, use only the referenced terminals.
Ampli er GTA 4 Special
The ampli er is suitable for connecting a car sound system
with cinch connections.
For the connection to car sound systems with ISO connec-
tion, use Blaupunkt ISO cinch adapters (7 607 893 093 or
7 607 855 094).
Application options and loudspeaker connection
Quadro mode
Max power 4 x 120 W / 4 Ω Fig. 4, 5
Stereo mode
Max power 2 x 380 W / 4 Ω Fig. 6
Quadro mode
Max power 4 x 190 W / 2 Ω Fig. 4, 5
Quadro mode
RMS power 4 x 60 W / 4 Ω Fig. 4, 5
Stereo mode
RMS power 2 x 160 W / 4 Ω Fig. 6
Quadro mode
RMS power 4 x 85 W / 2 Ω Fig. 4, 5
Frequency response 10 Hz - 25,000 Hz
Signal-to-noise ratio > 90 dB @ RMS power (4 Ω)
Signal-to-noise ratio > 73 dB @ 1 W / 1 kHz (4 Ω)
Distortion factor (RMS) < 0.05 %
Stability 2 Ω (4 Ω in bridge mode)
Input sensitivity 0.3 - 8 V
Low-pass  lter
(Low Pass) 50 - 250 Hz
High-pass  lter
(High Pass)
50 - 250 Hz
Bass boost 0 / 6 / 12 dB / 60 Hz
Dimensions
W x H x D (mm)
W x H x D (")
245 x 55 x 300
9.6 x 2.2 x 11.8
Plus / minus connection
We recommend a minimum cross section of 6 mm
2
.
Route commercially available plus cables to the battery
and connect via fuse holder.
Use cable glands for holes with sharp edges.
Securely fasten commercially available minus cables to a
noise-free earth point (chassis screw, chassis metal) (not
to the minus pole of the battery).
Scrap the contact surfaces of the earth point until they
are bright and grease with graphite grease.
Integrated fuses (Fuse)
The fuses integrated in the ampli er (Fuse) protect the power
ampli er and the entire electrical system in case of an error.
If a replacement fuse is used, never bridge fuses or replace
them with a type with higher current.
Connection examples
Connection of the voltage supply ............................... Fig. 2
Connection to car sound system with
cinch output .......................................................................Fig. 3
Loudspeaker connections .............................................Fig. 4/5/6
+12V
Remote connection of the ampli er with switchable +12 V
voltage source.
This allows the ampli er to be switched on and o using the
on/o -switch of the radio device.
Level control
The Level control is used to adjust the input sensitivity of
the power ampli er to the output voltage of your car sound
system preampli er output.
The adjustment range is from 0.3 V to 8 V.
If a car sound system of a third party manufacturer is con-
nected, the input sensitivity must be adjusted corresponding
to the manufacturer data.
A few important explanations in this context:
By turning the control clockwise, the input sensitivity of the
ampli er and, therefore, also the volume increases. However,
this is not a volume control; no further ampli er output
can be achieved in the end position, even if it may sound
like that at the beginning. The system merely increases the
volume faster if the volume control of the car sound system
is turned up.
Loudspeaker connections
(If the ampli er is to be jumpered, continue with the section
"Bridged loudspeaker connections" at this point).
As with every audio component, the correct polarisation of
ampli er and loudspeakers is of essentially importance for a
good bass response. For this reason, ensure that the positive
(+) connection of the ampli er is connected with the posi-
tive connection (+) of the loudspeaker; the same applies to
the negative (-) connections. In addition, the left ampli er
channel must be connected with the left loudspeaker and
the right ampli er channel with the right loudspeaker.
GTA_4_Special_22LG.indd 46GTA_4_Special_22LG.indd 46 01.11.2010 13:46:54 Uhr01.11.2010 13:46:54 Uhr
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt GTA 4 Special Edition 2011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt GTA 4 Special Edition 2011 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info