Manual Blaupunkt gta 1350 (page 6 of 28) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish)

163789

Zoom out

Zoom in

1/28

Safetyprecautions

Instructions for installation and

connection

Fit a fuse in the ampliﬁer power line no more

than 30 cm from the vehicle battery, in order

to protect the battery in the event of a short-

circuit between it and the power ampliﬁer. The

ampliﬁer’s own fuse protects the ampliﬁer its-

elf, but not the car battery.

Disconnect the negative terminal of the

battery before carrying out installation

and connection work.

Observe the vehicle manufacturer’s safety in-

structions (regarding airbags, alarm systems,

trip computers, vehicle immobilisers).

The ﬁnal stage must be installed professional

ly for reasons of safety. The mounting surface

must be suitable for the screws provided, and

must provide ﬁrm support. For safety reasons

the GTA 1350 should be ﬁxed in a reliable way.

You must not install the GTA 1350 on the rear

shelf, on the rear seats or on any other surface

open to the front.

When drilling holes, take care to avoid damage

to vehicle components (battery, cables, fuse bo

xes).

Fit the ampliﬁer in a suitable location, e.g.

beneath the seats or in the trunk (Fig. 1).

The mounting location must also be dry, and

provide sufﬁcient ventilation for cooling of

the ampliﬁer. Use cable grommets when pas

sing cables through holes with sharp edges.

Use loudspeakers with an impedance of

2 to 4  (see table or installation drawing). Ob

serve the max. power handling speciﬁcations

(music output). Do not connect the loudspea-

kers to ground; only use the terminals provided.

The cross-section of the positive and negative

cable must be at least 10 mm

GTA 1350 ampliﬁer

The ampliﬁer is suitable for connection to car

radios with Cinch connector. Use the Blaupunkt

ISO Cinch adapter to connect the ampliﬁer to

car radios with ISO connector (7 607 893 093/

7 607 855 094).

Applications and loudspeaker

connection

Max Power 1 x 750 Watt / 4  .........Fig. 4

Max Power 1 x 1000 Watt / 2 

.......Fig. 4

RMS Power 1 x 300 Watt / 4 

.........Fig. 4

RMS Power 1 x 500 Watt / 2 

.........Fig. 4

Frequency

response 10 Hz - 35.000 Hz

Signal-to-noise

ratio > 95 dB

Distortion factor RMS) < 0,03%

Stability 2 

Input-sensitivity 0,3 - 8 V

Low-pass ﬁlter 50-250 Hz

Bass Boost

0 dB to +12 dB

Subsonic ﬁlter 20-55 Hz

Inputs

2x Cinch/RCA, gold-plated

2x HighLevel speaker

Outputs 1x Loudspeakers, gold-plated

2x Cinch/RCA Preamp-out

Dimensions

W x H x D (mm) 402,5 x 53 x 268,5

Positive/negative connection

We recommend a cable cross-section of not

less than 6 mm

. Run a standard commercial

positive cable to the battery and connect to the

fuse holder. Use cable grommets when passing

cables through holes with sharp edges. Bolt a

standard commercial negative cable to a ground

point free of induced noise (car body bolt, body

panel) - not to the negative battery pole. Clean

the contact surface of the ground point down

to bare metal and coat with antiseize graphite

petroleum.

Integral fuses

The integral fuses within the ampliﬁer protect

the ﬁnal stage and the entire electrical system

in the event of a fault. Never bridge fuses or re

place fuses with a higher current rating.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt gta 1350 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 0,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Blaupunkt gta 1350 Manual

Product: