698862

Blaupunkt CMP401 Manual

8
Zoom out
Zoom in
Previous page
1/104
Next page
6
CMP401
will cause the coffee to have a burned and bitter taste and aroma.
Before frothing ensure the volume of milk is adequate in the cup. Milk can double in volume after
frothing, so care should be taken when deciding the volume of milk.
Use a heat-resistant cup for milk frothing. The cup can get very hot during frothing.
1. Turn on the milk frothing mode by pressing “steam switch” [4]. The LED control light will
start to blink. When the light starts to shine continuouslythe device is ready to generate
steam.
2. Rinse the steam tube [10] by turning the steam knob [9] anti-clockwise. Steam and some
water will come from the steam wand. Turn off the steam by turning the steam knob into 0
position [9] clockwise.
3. Immerse the steam tube [11] into the cup with cold milkand turn the steam knob [9] anti-
clockwise.
4. To end the milk frothing processturn the steam knob [9] into 0 position (clockwise). Take out
the steam tube [11] from the cup with milk. Never take the steam tube out of the cup if the
steam knob is not turned off to position 0. Hot steam may cause injuries and scalds.
5. After milk frothing it is advised to put the steam tube [11] into a cup with clean cold water
and rinse the system. After the steam tube is immersed in the cup with water turn the steam
knob [9] anti-clockwise. After few seconds, turn off the steam flow by turning steam [9] knob
clockwise.
6. Turn off the milk frothing mode by press the “steam switch” [4].
Cleaning and maintenance
Rinse the coffee maker's water system
1. Turn device on by pressing the On/Off switch [3]. Coffee maker will start to pre-heat, LED will
blink.
2. When coffee maker is ready, the LED will stop to blinking and flash constanley.
3. Place the filter holder [13] in the mounting point [17]. To Rinse the water system of coffee
maker. Press the button “One coffee” [1] and wait for the water to start flowing.
Regular cleaning after each use
Make sure that coffee maker has cooled down.
1. Remove the filter holder[13] by turning it left (clockwise). Remove the used coffee from filter
[12] and clean it with water.
2. Take the cup cushion and the drip tray out [5 and 6]. Both elements should be cleaned with
water and a little bit of dishwashing liquid.
3. Never immerse the device in water. The housing should be cleaned with a damp cloth, then a
dried with a dry cloth to remove moisture.
Regular descaling of coffee maker's water system
Depending on the hardness of the water descaling process must be performed every 2-3
months. Regular descaling of the machine protects the device and positively affects the
taste and aroma of the beverage.
WARNING: Lack of descaling causes a significant drop in performance and can lead to
damage of the device. Failure to descale the coffee maker will void the warranty.
Before descaling process, make sure that the device is disconnected from the power source.
1) Fillthe water tank with about 500 ml of water, and then add 250 ml of descaling liquid for
espresso machines (For a correct ratio refer to the manufacturers guide on the preparation of
descaling).
2) Place the filter holder into the filter holding mounting point. Place a cup with a little bit of
cold water under the steam tube and place an empty cup under the filter holder outlets.
3) Connect the device to a power source.
4) Turn on the coffee maker. When the indicator light stops blinking press “two coffee” switch.
Turn the steam knob anti-clockwise for few seconds, and close the hot water flow from the
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt CMP401 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt CMP401 in the language / languages: English, German as an attachment in your email.

The manual is 3,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info