698863
7
Zoom out
Zoom in
Previous page
1/104
Next page
1. On/Off switch
2. Coffee switch
3. Steam switch
4. Cup cushion
5. Drip tray
6. Steam control knob
7. Water tank cover
8. Detachable water tank
9. Cup warmer
10. Steam tube
11. Steam tube jacket
12. Filter holder's mounting point
13. Filter holder handle
14. Stainless steel filter
15. Press bar with spoon
16. Filter holder
17. Barometer
Before first use
It is recommended to rinse the coffee maker before the first use. The coffee maker should also be
rinsed after a longer period of time without use. Refer to the instruction in the Cleaning and
maintenance” chapter.
NOTE: When water system is empty, the water pump may work louder and device may vibrate more.
This is a common occurrence which will disappear after a given period of time.
Preparation of espresso coffee
1. Turn device on by pressing the On/Off switch [1]. Coffee maker will start to pre-heat, LED will
blink.
2. Choose the right filter [14 ] (for one cup, for two cups) and put it into the filter holder [16]
3. When coffee maker is ready, the LED will stop blinking and shine continuously.
4. Hold the filter holder [16] with filter inside [14] below the mounting point [12] and rinse it
with water to pre-heat it. Press the button “coffee switch [2] and wait for a few seconds, than
press “coffee switch” again to close the flow of the water.
5. Pour medium ground coffee powder into the filter [14] and pack the coffee gently. Clean the
rim of the filter holder [16] to remove any excess ground coffee.
ADVISE 1. Coffee ground too fine (like for brewed coffee), will block the flow of the water in
the filter. Coffee ground too coarse, will not release the full flavor and aroma of the coffee.
ADVISE 2. If coffee is packed too tightly, the flow of water can be obstructedand may scold
the coffee and cause the drink to have a burned aroma. It may even block the flow of water
totally. If the coffee is packed too loose it will not transfer enough taste and aroma into the
drink.
6. Place the filter holder [16] into the mounting point head [12]. Engravings on the filter holder
must fit in the slots of the filter holder's mounting point. Turn the filter holder all the way to
the right (clockwise).
7. Place cups under the outlets of the filter holder.
8. Press “coffee switch” [2] and wait for the right amount of coffee to pour into the cups
thenpress “coffee switch [2] again.
Frothing milk
It is advised to froth the milk after the coffee had been prepared as milk frothing mode requires a
higher temperature. After milk frothing it is necessary to wait a minimum of 5 minutes to allow the
device to cool down slightly. If the temperature of brewing is too high, the coffee can be scolded which
will cause the coffee to have a burned and bitter taste and aroma.
Before frothing ensure the volume of milk is adequate in the cup. Milk can double in volume after
frothing, so care should be taken when deciding the volume of milk.
Use a heat-resistant cup for milk frothing. The cup can get very hot during frothing.
1. Turn on the milk frothing mode by pressing “steam switch [3]. The LED control light will
5
CMP312
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt CMP312 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt CMP312 in the language / languages: English, German as an attachment in your email.

The manual is 3,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info