Barcelona CM 102
24
The sensitivity level can be varied in either
operating mode (lo and dx; see chapter “Pro-
gramming”).
Memorizing a Station
You can memorize a station with each of the
preset buttons >.
For FM, each preset button > can be alloca-
ted four times, i.e. four stations can be stored
on one button. The display B c shows you
the corresponding assignments (I, II, III stand
for first, second, and third allocation; T stands
for Travelstore (for Travelstore information
see the following chapter).
For changing the storage level:
● Press the 3FM button A.
to select the fourth storage level “Tra-
velstore”,
press the TS button @.
For storing a station:
● select the storage level (FM only). For
this, press 3FM until the display B c
shows I, II or III, or press the TS button
@.
● Tune in the station (see chapter Auto-
matic/Manual Tuning of Stations)
● Press the desired preset button > until
the broadcast becomes audible again
(approx. 2 seconds).
From the display B d you can see
which button is currently pressed.
Now the station is stored.
Note:
When tuning in an already stored station, the
display B d will show the corresponding
preset button for approx. five seconds. In
addition, for FM, the display B c will also
give you the storage level.
Automatically Storing the Stron-
gest Stations
(Travelstore)
With Travelstore, you have the opportunity to
automatically store the six strongest FM sta-
tions of your respective region and have
them sorted according to their signal strength.
This feature is of special use while travelling.
● Press the TS button @ for at least two
seconds.
The set searches for the strongest FM
stations and sorts them on the “T”
storage level (Travelstore). Once the
process is finished, the car radio auto-
matically tunes in to the strongest
station.
If required, it is also possible to manually
store a station on the Travelstore level. If less
than six stations can be received, the free
buttons are represented by dashes for a
short period of time.
Activating a Stored Station
If required, the memorized stations can be
activated at a keystroke.
● Choose the storage level (only FM).
For this, press 3FM A until the display
B c shows I, II or III, or press the TS
button @.
● Briefly press the corresponding preset
button >.
Briefly Sampling a Station
(Radio Scan)
Starting with the currently tuned in station,
you can have the following ones briefly sam-
pled for approx. eight seconds each.
● Briefly press the Scan button 1.
The display B a gives you “SCAN”. If
the following station is found, it is re-
produced for approximately eight se-
conds. The station’s frequency starts
blinking on the display B a; if it has
already been memorized, the corre-
sponding preset button starts blinking
on the display B d. In addition, for FM
stations, the storage level indicator
lights up on the display B c. Subse-
