en Operating the appliance
22
Optical display while the programme is running
Optical display while
the programme is running *
* depending on model
While the programme is running, a light
spot shines on the floor under
the appliance door. Do not open
the dishwasher door until the light point
is no longer visible on the floor.
If the door is not completely closed, the
light spot flashes. *
If the appliance is installed at eye-level,
with flush furniture front, the light point
is not visible.
This function can be changed as
follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button ` until
•:‹.... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display h displays
the factory setting •:‹….
5. Press programme button # until
the factory set value ‚:‹‚
is indicated on the digital
display h.
To change the setting:
1. By pressing the button 3, you can
switch the function off ‚:‹‹
or on ‚:‹‚.
2. Press START button `.
The set value is saved.
3. Close the door.
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display h.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display h jumps to œ:‹‚.
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
6. To delete timer programming, press
the P + or – button until h œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
