613319

Blaupunkt 5EE61350 Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
en
Ú
Ins tallation instructions
You must note the following
Electrical connection: Must only be carried out by a licensed
expert. Incorrect connection will invalidate the warranty.
Installation: Must only be carried out by a professional. The
fitter is liable for any damage.
Hob and cooker: Must only be from the same brand and have
the same combination feature.
Protection against accidental contact: Must be ensured
through the manner of installation.
Installation instructions: Must be observed for the cooker.
Work surface: Level, horizontal, stable.
Preparing the units - Figure 1
Fitting unit: Heat resistant to at least 90°C.
Cut-out: Minimum distance to the side walls: 70 mm.
After the cutting out work is complete, remove the shavings.
Cut surfaces: Seal with heat-resistant material.
Fitting the hob - Fig. 2
Cables: Do not trap cables when fitting.
Insert the hob in the existing worktop cut-out with a depth of
500 mm - Figure 3
1. Mark the centre of the cut-out
2. Put the hob in place
3. Align the markings on the hob surround and cut-out
4. Press in the hob.
Connecting the hob - Fig. 4
The cooker must be connected to the mains, but switched off.
1. Pull out the cooker far enough to make the socket accessible.
2. Screw the hob's PE conductor (green/yellow) onto the cooker
earthing point <.
3. Plug the hotplate plug into the cooker. The colour of the cable
must correspond to the colour shown on the label. The lug N
on the plug must point to the left.
Slide the cooker in. Do not trap the cable when fitting.
Tiled work surfaces: Seal the tile joints with silicone rubber.
Removing the hob
Disconnect the appliance from the power supply.
Pull out the cooker a short distance. Unplug the cooking zone
plug. Finally, disconnect the PE conductor (green/yellow) from
the earthing screw.
Push out the hob from below.
fr
Þ
Not ic e de mo ntage
Consignes à respecter
Connexion électrique : uniquement par un spécialiste agréé.
Toute erreur de branchement annule la garantie.
Encastrement : uniquement selon les règles de l'art,
l'installateur est responsable en cas de dommages.
Table de cuisson et cuisinière : uniquement de la même
marque et ayant le même point de combinaison.
Protection contre le contact : doit être garantie par
l'encastrement.
Notice de montage : de la cuisinière doit être respectée.
Plan de travail : plan, horizontal, stable.
Préparation du meuble - fig. 1
Meuble d'encastrement : résistant à une température d'au
moins 90°C.
Découpe : distance minimale vers les parois latérales : 70 mm.
Enlever les copeaux après les travaux de découpe.
Chants de la découpe : les sceller de façon thermostable.
Mise en place de la table de cuisson - fig. 2
Câbles : ne pas les coincer lors de l'encastrement.
Insertion de la table de cuisson en cas de présence de la
découpe du plan de travail d'une profondeur de 500 mm -
fig. 3
1. Marquer le milieu de la découpe
2. Poser la table de cuisson
3. Aligner les marquages du cadre de la table de cuisson et de
la découpe
4. Faire rentrer la table de cuisson en appuyant.
Raccordement de la table de cuisson - fig. 4
La cuisinière doit être raccordée au secteur, mais être hors
tension !
1. Insérer la cuisinière de sorte que le dispositif de connexion
soit accessible.
2. Visser le conducteur de protection PE (vert/jaune) de la table
de cuisson au point de mise à la terre
< de la cuisinière.
3. Connecter le connecteur des foyers à la cuisinière. La
couleur de la conduite avant doit correspondre au marquage
de couleur de l'autocollant. Le nez N du connecteur doit être
orienté vers la gauche.
Pousser la cuisinière vers l'intérieur. Ne pas pincer la conduite
électrique lors de l'encastrement.
Plans de travail carrelés : Etanchéifier les joints de carrelage
avec un joint en silicone.
Dépose de la table de cuisson
Mettre l'appareil hors tension.
Retirer légèrement la cuisinière. Débrancher le connecteur des
foyers. A la fin, détacher le conducteur de protection PE (vert/
jaune) de la vis de mise à la terre.
Sortir la table de cuisson en la poussant par le bas.
it
â
Istruzioni per il montaggio
Procedere nel modo seguente
Allacciamento elettrico: da far eseguire esclusivamente da un
tecnico specializzato. In caso di allacciamento scorretto decade
la garanzia.
Montaggio: da eseguirsi esclusivamente in modo corretto; in
caso di danni la responsabilità verrà imputata a chi ha eseguito
il montaggio.
Piano di cottura e cucina: devono essere della stessa marca e
dotati di un contrassegno identico.
Protezione da contatto: deve essere garantita tramite il
montaggio.
Rispettare le istruzioni di montaggio della cucina.
Piano di lavoro: stabile, in piano e orizzontale.
Preparazione del mobile: figura 1
I mobili da incasso: termostabili almeno fino a 90 °C.
Foro di incasso: distanza minima dalle pareti laterali: 70 mm.
Rimuovere i trucioli dopo i lavori di taglio.
Superfici di taglio: sigillare in modo refrattario.
Montaggio del piano di cottura: figura 2
Non schiacciare icavi durante il montaggio.
Montare il piano di cottura con foro d'incasso del presente
piano di lavoro con profondità 500 mm - Figura 3
1. Marcare il centro del foro d'incasso
2. Posizionare il piano di cottura
3. Allineare la marcatura sul telaio del piano di cottura a quella
sul foro d'incasso
4. Spingere il piano di cottura in sede.
Allacciamento del piano di cottura: figura 4
La cucina deve essere collegata alla rete di alimentazione ma
senza tensione!
1. Inserire la cucinain modo che il dispositivo di protezione sia
accessibile.
2. Avvitare il conduttore di terra PE (verde/giallo) del piano di
cottura al punto di messa a terra
< della cucina.
3. Inserire le prese delle zone di cottura nella cucina. Il colore del
cavo anteriore deve corrispondere all'indicazione sull'adesivo.
La sporgenza N del conduttore deve trovarsi a sinistra.
Inserire la cucina. Durante il montaggio non schiacciare il cavo.
Piani di lavoro piastrellati: chiudere a tenuta le fughe tra le
piastrelle utilizzando gomma siliconica.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt 5EE61350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt 5EE61350 in the language / languages: All languages as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Blaupunkt 5EE61350

Blaupunkt 5EE61350 User Manual - English, German, Dutch, French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info