Manual Black Decker STC5433B (page 10 of 124) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

709494

Zoom out

Zoom in

1/124

ENGLISH

(Original instructions)

Assembly

Warning! To reduce the risk of serious personal injury, turn

unit off and remove the battery pack before making any

adjustments or removing/installing attachments or

accessories. An accidental start-up can cause injury.

Assembly tools required

u Phillips Screwdriver (not supplied).

u Hex wrench (supplied).

Installing the guard

Warning! Never operate appliance without the guard (13)

rmly in place. The guard must always be properly attached

on the appliance to protect the user.

u Remove the screw from the guard.

u Turn the trimmer upside down so that you are looking

down at the spool cap ( 20 ).

u Turn the guard (12) upside down and slide it fully onto the

trimmer head (10). Make sure the tabs ( 16 ) on the guard

engage the ribs (17) on the trimmer head as shown.

u Continue to slide the guard on until you hear it “snap”

into place. The locking tab (18) should snap into the

housing slot (19) as shown in gure G.

u Using a phillips screwdriver, insert the guard screw and

tighten securely as shown in gure H to complete the

guard assembly.

u Once the guard is installed, remove the covering from

the line cut-off blade, located on the edge of the guard.

Assembling the Pole

u To assemble the pole, line up the upper trimmer pole

(6) and the lower trimmer pole (7) as shown in gure I.

Press down the latching button (20) and slide the upper

pole into the lower pole. Ensure the latching button

engages the latch hole (21).

u Secure the poles by tightening the middle bolt (22) with

the supplied hex wrench (23) as shown in gure J.

Attaching the auxiliary handle

u Place the auxiliary handle (5) onto the top of the upper

trimmer pole (6) as shown in gure K.

u Slide the bracket (24) of the auxiliary handle onto the

bottom of the handle.

u Thread the handle bolts (25) through the handle and

into the bracket from above.

u Tighten the handle bolts. Ensure the handle is securely

attached by closing the handle clamp (26).

u To adjust the position of the auxiliary handle, open the

handle clamp and slide the handle up and down the

pole until it is in the desired location. Close the clamp to

lock the handle in place.

Releasing the cutting line

For shipping purposes, the cutting line is taped to the spool

housing.

u Remove the tape holding the cutting line to the spool

housing. See "Replacing the Spool" for instructions for

removing the spool.

Charging procedure (STC5433 unit only)

BLACK+DECKER chargers are designed to charge

BLACK+DECKER battery packs.

u Plug the charger (15) into an appropriate outlet before

inserting the battery pack (14).

u Insert the battery pack (14) into the charger (15) as shown

in gure A.

u The green LED (15a) will ash indicating that the battery is

being charged.

u The completion of charge is indicated by the green LED

(15a) remaining on continuously. The pack is fully charged

and may be used at this time or left on the charger.

Note: Recharge discharged batteries as soon as possible

after use or battery life may be greatly diminished. For longest

battery life, do not discharge batteries fully.

It is recommended that the batteries be recharged after each

use.

Leaving the battery in the charger

The charger (15) and battery pack (14) can be left connected

with the LED glowing indenitely. The charger will keep the

battery pack fresh and fully charged.

Important charging notes

u Longest life and best performance can be obtained if

the battery pack is charged when the air temperature is

between 65°F and 75°F (18°- 24°C). DO NOT charge the

battery pack in an air temperature below +40°F (+4.5°C),

or above +105°F (+40.5°C). This is important and will

prevent serious damage to the battery pack.

u The charger and battery pack may become warm to touch

while charging. This is a normal condition, and does not

indicate a problem. To facilitate the cooling of the battery

pack after use, avoid placing the charger or battery pack

in a warm environment such as in a metal shed, or an

uninsulated trailer.

u If the battery pack does not charge properly:

u Check current at receptacle by plugging in a lamp or

other appliance.

u Check to see if receptacle is connected to a light switch

which turns power off when you turn out the lights.

u Move charger and battery pack to a location where the

surrounding air temperature is approximately 65°F

- 75°F (18°- 24°C).

u If charging problems persist, take the tool, battery pack

and charger to your local service center.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker STC5433B in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,17 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker STC5433B Manual

Product: