472996
26
Zoom out
Zoom in
Previous page
1/72
Next page
26
ENGLISH
Never attempt to connect two chargers together.
Always disconnect the supply before making or
breaking connections to the battery.
Be aware that this tool is always in an operating
condition, because it does not have to be plugged
into an electrical outlet. Keep the switch control
lever in the “Off” position when the tool is not in use
or when changing accessories.
When drilling or driving screws into walls, floors
etc., check wherever “live” electrical wires may be
encountered. Do not touch any front metal parts of
the tool! Hold the tool only by the plastic housing.
Do not store the tool in locations where the
temperature may reach or exceed 50˚C (120˚F) (such
as outside sheds or metal buildings in summer).
Do not incinerate the drill/driver even if it is severely
damaged or completely worn out. The battery pack
can explode in a fire.
A small leakage of liquid from the battery cells may
occur under extreme usage, charging or
temperature conditions. This does not indicate a
failure. However, if the outer seal is broken and this
leakage gets on your skin:
Wash quickly with soap and water.
Neutralise with a mild acid such as lemon juice
or vinegar.
If battery liquid gets into your eyes, flush them
with clean water for a minimum of 10 minutes and
seek immediate medical attention.
(Medical note: The liquid is a 25-35% solution of
potassium hydroxide.)
Do not attempt to open the housing of your drill or
charger.
The supply cord of the charger should not be
replaced by the customer; if the cord is damaged it
should be replaced at an authorised Black & Decker
service repair agent.
Ensure that the battery pack is correct for the tool.
Ensure that the outside surface of the battery pack
or tool is clean and dry before plugging into the
charger.
Ensure that the battery is charged using the correct
charger provided with the tool or recommended by
the manufacturer. Incorrect use may result in a risk
of electric shock, overheating or leakage of
corrosive liquid from the battery.
Do not attempt to recharge non-rechargeable
batteries.
Save these instructions!
ELECTRICAL SAFETY
Be sure the supply is the same as the voltage given on the
rating plate. Your charger is fitted with a two-core cable
and plug.
MAINS PLUG REPLACEMENT
Should the mains plug or cordset of the product be
damaged, it must only be replaced by an authorised
Black & Decker service agent because special
purpose tools are required.
MAINS PLUG REPLACEMENT ON 1 HOUR CHARGER
(UK ONLY)
If you are using a 1 hour charger and the mains plug
needs replacing, and you are competent to do this,
proceed as instructed below.
If you are in doubt, contact a Black & Decker service
agent or a qualified electrician.
Disconnect the plug from the power supply.
Cut off the plug and dispose of safely. A plug with
bared copper conductors is very dangerous if
engaged in a live socket outlet.
Only fit BS1363A approved plugs fitted with the
correctly rated fuse.
Note: Fuses do not give personal protection against
electric shock.
The cable wire colours, or a letter, will be marked at
the connection point of most good quality plugs.
Attach the wires to their respective points in the
plug (see diagram). Brown is L (live) and blue is N
(neutral).
Fit a plug
approved
to BS1363A
Connect
blue to
N (neutral)
Make sure that
the outer sheath
of the cable is held
firmly by the clamp
Fit a 5 amp fuse
Connect
brown to
L (live)
240 volts AC
only. Never use
a light socket
N
L
E
Before replacing the top cover of the plug ensure
that the cable restraint is holding the outer sheath of
the cable firmly and that the two leads are correctly
fixed at the terminal screws. If the fuse cover is
missing or damaged do not use the plug.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker KC7251 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker KC7251 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info