578632

Black Decker HVLP200 T1 Manual

11
Zoom out
Zoom in
Previous page
1/112
Next page
11
ENGLISH
(Original instructions)
u Maintain smooth and consistent speed which will help
avoid inconsistencies. Begin spraying after the pass has
begun and release trigger before stopping the pass.
u Avoid spraying too heavily in any one area. Several lighter
coats are better than one heavy coat which can lead to
running and dripping. Remember that the ow control
knob regulates the amount of liquid that can be sprayed.
Turning the ow knob clockwise increases the ow of
liquid. Turning the knob counterclockwise decreases the
ow of liquid. If runs or drips do occur, have a dry paint
brush on hand to smooth them out.
u Turn the power unit off and place the sprayer in the built-in
dock of the power unit when not spraying for any length of
time.
Maintenance and cleaning
Your Black & Decker corded appliance has been designed to
operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper appliance care and regular cleaning.
Warning! Be sure to use appropriate personal protective
equipment.
Warning! Before performing any maintenance or cleaning on
corded appliances switch off and unplug the appliance.
Warning! Do not use materials with a ashpoint lower than
55°C. Flashpoint is the temperature that a uid can produce
enough vapours to ignite (see paint supplier instructions).
Warning! Make sure clean up area is well ventilated and free
of ammable vapours.
Warning! Always spray outdoors when spraying cleaning
solution through sprayer.
Warning! Do not submerse power unit.
Flushing the sprayer (g. N)
u Disconnect the sprayer from the power supply.
u Unscrew the lid from the side of the canister and pour any
remaining liquid back into the original container (g. N).
u Pour a small amount of the appropriate cleaning solution
into the canister.
t Warm soapy water for water based materials.
t Manufacturers recommended cleaning solution for oil
based materials.
u Replace the lid on the canister securely and vigorously
shake the sprayer.
u Unscrew the lid from the side of the canister and properly
dispose of cleaning solution.
u Rell the canister with a small amount of new cleaning
solution. Screw lid securely on canister.
u Reattach the sprayer to the motor unit, plug in the cord
and turn on the power unit.
u Spray the cleaning solution through the sprayer onto scrap
material for 2 to 3 seconds.
Cleaning the sprayer (g. O - S)
u Disconnect the sprayer from the power supply.
u Remove the side ll canister (6) and unscrew the side
lid (7). Remove the check valve (18), pickup tube (15)
and o-ring (17) from the sprayer. Clean the parts in the
appropriate cleaning solution (g. O).
u Unscrew the tip collar (19) and remove the spray nozzle
(10) and spray tip (20). Clean all parts in the appropriate
cleaning solution (g. P).
u If using water based material, clean the sprayer by running
water through pickup tube inlet. If using oil based materi-
als, clean pickup tube inlet with the appropriate cleaning
solution. Repeat until sprayer is completely clean. Take
special care to gently clean the spraying needle (21).
u Dry all parts thoroughly.
u Properly dispose of cleaning solution.
u Place a drop of household oil onto the metal ball in the
check valve (18) (g. Q).
Important : Lubricating the ball in check valve (18), after
cleanup, will help to prevent it from sticking which can clog the
valve and prevent adequate ow of spray material.
Note : When reassembling, place metal ball end of check
valve (18) into sprayer.
u Reassemble sprayer (g. S).
Note : The spray tip (20) can only go in one way. The notch
(22) on the spray tip must align with the recess in the threads
of the sprayer (g. R).
Cleaning the power unit
u Disconnect the sprayer from the power supply.
u Use only mild soap and damp cloth to clean the power
unit.
Warning! Never let any liquid get inside the power unit.
Warning! Never immerse any part of the power unit into a
liquid.
Cleaning the lter
The power unit contains a washable/reusable lter (g. T).
Check the lter before and after each use. If dirty, wash with
warm water and allow to air dry before re-installing or replace
if necessary.
u To check the lter, remove the lter cover (11) by removing
the 2 screws from the top of the lter cover then pulling
the cover off the power unit.
u Remove the lter (23) and inspect.
u Replace the lter and lter cover.
Warning! Never operate the power unit without the lter in
place. Debris could be sucked in and interfere with the func-
tion of the power unit.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker HVLP200 T1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker HVLP200 T1 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 6,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker HVLP200 T1

Black Decker HVLP200 T1 Quick start guide - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info