584865
8
Zoom out
Zoom in
Previous page
1/16
Next page
8
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Features
1. On/off switch
2. Carrying strap
3. Wand
4. Wand handle
5. Tank cap
6. Suction tube
7. Nozzle
8. Power head
9. Tank
Assembly and adjustment
Warning! Make sure that the sprayer is switched off.
Attaching the carrying strap (fig. A)
Attach the clips (10) of the strap (2) to the openings (11)
on the power head.
Assembling the spray wand (fig. B)
Insert the wand (3) into the wand handle (4) until it locks
into place.
Tighten the cap (12) onto the handle.
Fitting the nozzle (fig. C)
Screw the nozzle onto the handle tip (13).
Adjusting the cone type nozzle
Turn the nozzle clockwise for narrow misting applications.
Turn the nozzle counterclockwise for wide misting
applications..
Removing and replacing the power head (fig. D1 - D3 & E)
Unscrew the tank cap (5) (fig. D1).
Remove the suction tube (6) from the tank (9).
Release the latch (14) by pressing it downward (fig. E).
Raise the back of the power head (8) and move it forward
(fig. D2).
Pull off the power head.
To attach the power head, align the slots (15) in the
power head with the tabs (16) on top of the tank (fig. D3).
Move the power head backward until it locks into place.
Fit the bracket (17) over the latch attachment (18) (fig. E).
Push the ledge upward until it locks into place.
Place the suction tube in the tank.
Replace the tank cap and tighten it.
Use
Warning!
Use safety equipment.
Only spray in well-ventilated areas.
Only use recommended chemicals as described in the
safety instructions.
Charging the battery
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before. When charging the battery for the
first time, or after prolonged storage, it will only accept an
80% charge. After several charge and discharge cycles, the
battery will attain full capacity. The battery may become warm
while charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Pull out the socket cover (19).
Insert the charger plug (20) into the charger connector (21)
at the rear of the appliance.
Plug in the charger. Switch on at the mains.
Leave the appliance connected to the charger for 14-18
hours.
Whilst charging, the charger may become warm. This is normal
and does not indicate a problem. The appliance can be left
connected to the charger indefinitely.
Before using the appliance, unplug the charger and
disconnect the appliance from the charger.
Replace the socket cover.
Warning! The appliance does not operate while it is connected
to the charger.
Filling the tank (fig. D1)
Unscrew the tank cap (5).
Remove the suction tube (6) from the tank (9).
Fill the tank with an appropriate liquid.
Warning! Only use appropriate chemicals as described in the
safety instructions.
Switching on and off
To switch on, press the button (1).
To switch off, release the button.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GSC500 TH1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GSC500 TH1 in the language / languages: English as an attachment in your email.

The manual is 1,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker GSC500 TH1

Black Decker GSC500 TH1 User Manual - English, German, Dutch, Danish, French, Italian - 92 pages

Black Decker GSC500 TH1 User Manual - Polish - 16 pages

Black Decker GSC500 TH1 User Manual - Portuguese, Swedish, Spanish, Norwegian, Finnish - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info