474480

Black Decker GRC950 Manual

7
Zoom out
Zoom in
Previous page
1/38
Next page
7
through the blade. Ensure to align the
inside edges with the outside edges of
the blade.
H4
• Place the square steel blade spacer on
the motor shaft aligning the inside flats
with the shaft and engaging the outside
edges with the plastic clutch plate.
Engage nut on shaft and turn it
clockwise to tighten.
• Ensure that removed parts are replaced
correctly before use, incorrect assembly
may result in damage to your mower
and reduced cutting performance.
Note: This unit is fitted with a clutch plate
(16), between the blade nut and the blade,
which must be assembled correctly at all
times. Damaged blade assembly parts
must be replaced before use.
Care and maintenance
The advice given in this section covers the general
care and maintenance of the main body of your
mower. Advice relating to the blades is given in
“Maintenance of blades”. Advice relating to the
maintenance and storage of the battery is given in
“Battery information”.
• Always keep your mower clean and free from
grass cuttings, especially the underside of the
cutter deck and the air vents.
• At the end of each cutting session we
recommend that the build up of grass on the
underside of the cutter cover is removed using
a blunt scraper. The spanner included with this
mower may also be used for this purpose.
• Clean all plastic components with a damp
cloth.
Caution: Do not use solvents or cleaning fluids as
these may damage the plastic components of your
mower.
Overload protection (Fig. J)
• Your machine is fitted with overload
protection. If you work too quickly in
long grass, or in heavy conditions, you
may overload the motor. If this occurs,
the safety key fuse will blow, causing
the machine to stop.
• This is not a fault of the machine but a
safety device to protect your machine.
J
• When this occurs, remove the safety
key and inspect the fuse link. If link is
broken, the fuse has blown and needs
to be replaced with a new key. One of
which is supplied as a spare in your
parts pack. Alternatively, you can
purchase a new key from any Black &
ENGLISH
Decker service centre.
To obtain the best results:
• Cut the grass regularly.
• Do not cut wet grass.
• When the grass is longer than 10cm
(4 inches), it is advisable to go over the
lawn on a high cut setting and then
finish using a lower setting.
Fault finding
If your mower does not operate correctly,
use the table below to locate the problem.
Problem Solution
Mower does not run (a) Check to make sure the safety
when switch lever key has been inserted correctly.
is activated (b) Remove the safety key, turn
your mower over and check that
the blade is free to turn.
(c) Has battery been fully charged?
Re-charge battery.
Mower stops when (a) Remove safety key. Turn your
mowing mower over and check that blade
is free to turn.
(b) Raise cutting height of wheels
and start mower.
(c) Has battery been fully
charged. Re-charge battery.
(d) Inspect safety key fuse link. If
broken, the safety key has blown
and requires replacement.
Mower runs but (a) Has battery been fully
cutting performance charged? Re-charge battery
is unsatisfactory (b) Battery may need replacing.
Refer to ‘Battery disposal’ section.
Mower is too hard (a) Raise cutting height to
to push reduce drag on grass. Check
each wheel for ease of rotation.
Mower is abnormally (a) Remove safety key. Turn unit
noisy and vibrates on its side and check blade for
damage. If damaged, replace with
Black & Decker replacement blade.
(b) If there is no visible damage
to the blade or underside of the
mower return to your local
service agent.
!
Warning! Always remove safety key before
carrying out any inspection.
GRC450/750 ML p01-38 16/3/00, 3:13 pm7
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GRC950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GRC950 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info