Manual Black Decker GRC950 (page 4 of 38) (English, German, Dutch, French, Italian, Portuguese, Spanish)

474480

Zoom out

Zoom in

1/38

• Tough, durable plastic deck which will

not rust and contributes to low noise and

low vibration.

• Powerful and efficient permanent magnet

motor which gives effective cutting and

bagging in all reasonable conditions and

a low noise level.

• The GRC450 will have a run time under

average cutting conditions of

approximately 450m

. The GRC750 will

have a run time under average cutting

conditions of approximately 750m

This run time will vary upwards and

downwards dependant upon grass

conditions, cut height used and

push speed.

Unpacking and assembly

Your mower carton contains:

• The mower and handle assembly.

• One hardware bag containing:

• Two safety keys (23).

• Instruction literature.

• Blade nut spanner (4).

• Charger (22).

• Battery strap (27).

• One grassbox assembly - see below for

assembly instructions.

Handle assembly (Fig. B)

Remove all the parts from the carton and

familiarise yourself with the individual parts of

your mower.

The main parts of your mower are your

mower body (1) which comprises a motor

cover (2), wheels (3) and grass flap (24).

The handle comprises the upper handle (5),

cross bar (20), lower handle (6), switch box

(7), switch lever (8), safety lock-off (9), cable

clips (11) and wing nut and cup (12).

• Assemble left lower leg (6L) and right

lower leg (6R) onto cross member (20).

Clip upper handle (5) over cross member

ends, and fasten into place with nuts (12).

To assemble the lower handle (6) into the

correct locations on your mower body (1),

proceed as follows:

• Insert the lower handles into the two

holes in your mower body (1) and press

down until secure. Secure in position

using the screws supplied (13).

Height of cut adjustment (Fig. C)

Warning! Remove safety key before

making any adjustments and give the blade

time to stop rotating; cutting blades are

sharp.

Each of the two axle wheels has its own

means of height adjustment which gives

3 cutting height positions.

• To select a height of cut, move the

wheels (3) into the slot required using the

spring system (16).

• Fit the other three wheels in the same way.

To ensure an even cut, please make sure

that all four wheels are placed in the same

position.

Grassbox assembly (Fig. D)

Read the safety instructions at the beginning

of this manual before using this accessory.

• The grassbox is a two piece (14 & 15)

plastic construction which needs to be

assembled before attaching it to your

mower.

To assemble the grassbox, proceed as

follows:

• Align both parts together.

• Clip in place.

Fitting the grassbox to your mower:

• The spring loaded grass flap is lifted and

the two arms on the front edge of the

grassbox are located behind the two lugs

rising up from the rear edge of the cutter

deck (Fig. D3).

• The grass flap can now be released to

lock the grassbox into position.

Removing the grassbox from your mower:

The full grassbox may be removed by raising

the grassflap and then either lifting the

grassbox up and then resting it on the lawn,

while the grassflap is gently lowered, leaving

both hands free to gently lift the full grassbox.

Battery information

• The battery in your cordless lawnmower is a

12 volt or 24 volt sealed lead acid system. The

battery employs an absorbed electrolyte and,

can therefore, be stored in any position without

fear of leakage.

• The battery has been charged at the factory,

however, it will be necessary to recharge the

battery for a minimum of 8 hours to ensure

full charge before initial use.

GRC450/750 ML p01-38 16/3/00, 3:13 pm4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GRC950 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker GRC950 Manual

Product: