585881

Black Decker GPC1800NM TH1 Manual

10
Zoom out
Zoom in
Previous page
1/124
Next page
• Tighten the screws (16) using the Allen key
provided.
• Adjust the chain tension as described below.
To ensure continued safe operation, the chain
and guide bar must only be replaced with original
Black & Decker parts. Replacement chain part
number A6158 replacement guide bar part number
623381-00.
Checking and adjusting the chain tension
(g. G)
• Check the saw chain tension. The tension is
correct when the saw chain (7) snaps back
after being pulled away 3 mm from the saw
chain bar with light force from the middle nger
and thumb. There should be no ‘sag’ between
the guide bar (6) and the saw chain (7) on the
underside.
To adjust the tension:
• Loosen the screws (16).
• Turn the screw (18) clockwise.
Warning! Do not over-tension the chain as this
will lead to excessive wear and will reduce the
life of the bar and chain.
• Once the chain tension is correct, tighten the
screws (18).
Warning! When the saw chain is new, check the
tension frequently during the rst two hours of
use as a new saw chain stretches slightly.
Oiling the chain
The saw chain must be oiled before each use and
after cleaning using only the correct grade of oil
(cat. no. A6027).
• Oil the whole saw chain (7) evenly using the
applicator (9).
Storage
When the tool will not be used for several months,
ideally leave the battery connected to the charger.
Otherwise proceed as follows:
• Fully charge the battery.
• Remove the battery from the tool.
• Store the tool and battery in a secure and dry
location.
• The storage temperature must always remain in
the range of +10 °C to +40 °C. Place the battery
on a level surface.
• Before using the tool after prolonged storage,
fully charge the battery again.
Protecting the environment
Z
Separate collection. This product must
not be disposed of with normal house-
hold waste.
Should you nd one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
z
Separate collection of used products
and packaging allows materials to
be recycled and used again. Reuse
of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collec-
tion of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
Black & Decker provides a facility for the collection
and recycling of Black & Decker products once
they have reached the end of their working life. To
take advantage of this service please return your
product to any authorised repair agent who will col-
lect them on our behalf.
You can check the location of your nearest author-
ised repair agent by contacting your local Black
& Decker ofce at the address indicated in this
manual. Alternatively, a list of authorised Black &
Decker repair agents and full details of our after-
sales service and contacts are available on the
Internet at:
www.2helpU.com
Batteries
Z
At the end of their useful life, discard
batteries with due care for our environ-
ment
• Do not short-circuit the battery terminals.
• Do not dispose of the battery(s) in a re as
this may result in a risk of personal injury or an
Explosion.
• Run the battery down completely, then remove
it from the tool.
• Batteries are recyclable. Place the battery(s)
in a suitable packaging to ensure that the
terminals cannot be short-circuited. Take
them to any authorised repair agent or a local
recycling station.
10
ENGLISH
(Original instructions)
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker GPC1800NM TH1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker GPC1800NM TH1 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 4,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Black Decker GPC1800NM TH1

Black Decker GPC1800NM TH1 Quick start guide - English - 16 pages

Black Decker GPC1800NM TH1 User Manual - Polish - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info