Manual Black Decker FSMH1321JSM (page 8 of 80) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

709563

Zoom out

Zoom in

1/80

ENGLISH

(Original instructions)

Attaching the hand held steam cleaner (Fig. B)

u Holding the back of the steam mop body (11) push the

hand held steam cleaner (5) rmly into the steam mop

body (11) making sure it sits correctly over the interface

(11a) and clicks securely into place.

Removing the hand held steam cleaner (Fig. B)

u Push the release button (10) on the main body (11) and lift

the hand held steam cleaner (5) off the interface (11a) and

away from the main body (11).

Attaching a cleaning pad (Fig. C)

Replacement cleaning pads are available from your

BLACK+DECKER dealer :- (cat no. FSMP20-XJ).

u Place a cleaning pad (13) on the oor with the velcro 'loop'

side facing up.

u Lightly press the steam mop down onto the cleaning pad

(13).

Note: This unit may be supplied with a standard oor cleaning

head (12) or a steam burst cleaning head (12a). In either case

use these instructions to t a cleaning pad.

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop

with the handle (8) supported in the upright position when

stationary and make sure the steam mop is turned off when

not in use.

Removing a cleaning pad

Caution! Always wear suitable shoes when changing the

cleaning pad on your steam mop.

Do not wear slippers or open toed footwear.

u Return the handle (8) to the upright position and turn the

steam mop 'OFF'.

u Wait until the steam mop cools down (approximately 5

minutes).

u Lift the steam mop away from the cleaning pad freeing it

from the velcro fastening.

Caution! Never leave the steam mop in one spot on any

surface for any period of time.

Always place the steam mop with the handle (8) supported in

the upright position when stationary and make sure the steam

mop is turned off when not in use.

Filling the water tank (Fig. Q)

Note! Fill the water tank with clean tap water (Do not use any

additives or chemicals).

Note! In areas of hard water, the use of de-ionised water is

recommended.

u Open the ller cap (4) by ipping it up.

u Fill the water tank with water (Do not use any additives or

chemicals).

Warning! When lling, detach from main unit and maintain in

a horizontal position.

Warning! Your water tank has a 0.5 litre capacity. Do not over

ll the tank.

u Close the ller cap (4).

Note! Ensure the ller cap is rmly secured.

Attaching the carpet glider (12b) (For use on

carpets only)

u Place the carpet glider (12b) on the oor.

u Attach a cleaning pad to the oor cleaning head (12)

u Lightly press the steam mop down onto the carpet glider

(12b) until it clicks into place.

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop

with the handle (8) supported in the upright position when

stationary and make sure the steam mop is turned off when

not in use.

Removing the carpet glider

Caution! Always wear suitable shoes when changing the

carpet glider on your steam mop. Do not wear slippers or

open toed footwear.

u Return the handle (8) to the upright position and turn the

steam mop 'OFF'.

u Wait until the steam mop cools down (approximately 5

minutes).

u Place the front of your shoe onto the carpet glider removal

tab and press down rmly.

u Lift the steam mop up and off the carpet glider.

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop

with the handle (8) supported in the upright position when

stationary and make sure the steam mop is turned off when

not in use.

Attaching the hose and accessories to the

hand held steam cleaner (Fig. G - O)

Warning! Inspect the seal between the connection point on

the hand held steam cleaner (5) and the steam hose (16)

before each use. If the seal malfunctions or is damaged,

please contact your nearest authorised repair agent. Do not

use the appliance.

Attaching the hose

u Press the steam hose release button (16a) on the steam

hose (16).

u Connect the steam hose (16) to the hand held steam

cleaner (5) and release the steam hose release button

(16a) making sure it clicks into place.

Important! Ensure that the steam hose (16) is securely

connected to the hand held steam cleaner (5). If steam

escapes from the joint, the hose is incorrectly tted. Switch off,

allow the unit to cool then remove and ret the hose.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker FSMH1321JSM in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker FSMH1321JSM Manual

Product: