709558

Black Decker FSMH1321 Manual

10
Zoom out
Zoom in
Previous page
1/80
Next page
10
ENGLISH
(Original instructions)
Using Autoselect
TM
, choose from one of the following
applications by turning the Autoselect
TM
dial (2) until the
required setting is selected.
Setting Mop Hand held
Wood/Laminate High temperature steam for
windows
Stone/Marble
 
Tiles/Vinyl Low temperature steam for
heavy grime
  
The steam mop will select the correct volume of steam
required for your particular cleaning operation.
Note: Always check you are using the correct setting before
using your steam mop.
Steam Burst (Fig. C1) (only available with units
FSMH1310SM, FSMH13151SM)
The oor head (12a) is equipped with a steam burst pedal to
aid in the removal of stubborn marks and stains.
u During use, press the steam burst pedal to apply extra
cleaning power.
u To revert back to normal setting press the pedal again.
Hints for optimum use
General
Caution: Never use the steam mop without rst attaching a
cleaning pad.
u Always vacuum or sweep the oor before using the steam
mop.
u The easiest way to use the appliance is to tilt the handle
to a 45º angle and clean slowly, covering a small area at a
time.
u Use water only with no additives or chemicals with your
steam mop. To remove stubborn stains from vinyl or
linoleum oors, you can pre-treat with a mild detergent
and some water before using the steam mop.
Steam Cleaning with the mop
u Fit hand held steam cleaner (5) to the steam mop body
(11)
u Place a cleaning pad (13) on the oor with the velcro 'loop'
side facing up.
u Lightly press the steam mop down onto the cleaning pad
(13).
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Turn the Autoselect
TM
dial (2) until the required setting is
reached. After a few seconds steam will start to come out
of the steam head.
Note! When rst lled or after running dry, it can take up to 45
seconds for steam to be produced.
u It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
u Push and pull the steam mop slowly across the surface to
thoroughly steam clean each section.
u When you have nished using the steam mop, return
the handle (8) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately ve minutes).
Caution! It is important to monitor the water level in the
water tank. To rell the water tank and continue to sanitize/
clean stand the mop upright making sure that the handle is
supported and turn the steam mop 'OFF'. Unplug the unit from
the electrical wall outlet, and rell the water tank.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (8) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Carpet refreshing
u Place a cleaning pad (13) on the oor with the 'loop' side
facing up.
u lightly press the steam mop down onto the cleaning pad.
u Place the carpet glider (12b) on the oor.
u Lightly press the steam mop down onto the carpet glider
until it clicks into place.
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Turn the Autoselect
TM
dial (2) to the Wood/Laminate
setting.
u Push and pull the steam mop slowly across the carpet to
thoroughly refresh each section.
u When you have nished using the steam mop, return the
handle (8) to the upright position and turn the unit OFF.
Wait until the steam mop cools down (approximately ve
minutes).
After use
u Turn the Autoselect
TM
dial (2) to the OFF position.
u Wait until the steam mop cools down.
u Unplug the steam mop from the electrical wall outlet.
u Empty the water tank.
u remove the cleaning pad (13) and wash it ready for next
use (take care to follow the wash care instructions printed
on the cleaning pad).
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker FSMH1321 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker FSMH1321 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info