Manual Black Decker FSM 1630S (page 5 of 56) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

526074

Zoom out

Zoom in

1/56

ENGLISH

(Original instructions)

Caution! Always place your steam mop with the handle (4) in

the upright position when stationary and make sure the steam

mop is turned off when not in use.

Removing the carpet glider (Fig. G)

Caution! Always wear suitable shoes when changing the

carpet glider on your steam mop. Do not wear slippers or

open toed footwear.

u Return the handle (4) to the upright position and turn the

steam mop ‘OFF’.

u Wait until the steam mop cools down. (approximately ve

minutes)

u Place the front of your shoe onto the carpet glider removal

tab (16) and press down rmly.

u Lift the steam mop up off the carpet glider (7).

Caution! Always place your steam mop with the handle (4) in

the upright position when stationary and make sure the steam

mop is turned off when not in use.

Fitting a scent pack (Fig. J & K)

Warning! Return the handle (4) to the upright position and

turn the steam mop ‘OFF’. Wait until the steam mop cools

down. (approximately ve minutes).

u Slide the door release button (23), the door will open.

u Place the scent pack into the cavity (24).

u Close the door (25) py pushing it rmly down.

Use

Important! This unit will kill 99.9% of bacteria & germs when

used in accordance with this manual and with the micro bre

pad tted and a continuous run time of 90 seconds.

Switching on and off

u To switch the appliance on, press the ON/OFF button (1).

It takes approximately 15 seconds for the steam mop to

heat up.

Note: When the steam mop is rst turned on the water res-

ervoir will glow red. Once the steam mop is ready to use the

water reservoir will glow blue.

u To switch the appliance off, press the ON/OFF button (1).

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop

with the handle (4) in the upright position when stationary and

make sure the steam mop is turned off when not in use.

Caution! Always empty the steam mop after use.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

Autoselect

Technology (Fig. H)

This steam mop is tted with an Autoselect

button (2)

which shows various cleaning applications. They are used to

select the correct operating mode for your particular cleaning

operation.

Using Autoselect

, choose from one of the following applica-

tions by pressing the autoselect button (2) until the required

setting is selected:

Wood/Laminate

Stone/Marble

Tiles/Vinyl

The steam mop will select the correct volume of steam

required for your particular cleaning operation.

Note: Always check you are using the correct setting before

using your steam mop. For convienience the steam mop will

remember the last setting you chose.

Steam burst (Fig. H)

The steam mop is equipped with a steam burst button to aid in

the removal of stubborn marks and stains.

u During use, press the steam burst button (21) to apply

extra cleaning power.

Note: The stem burst will last for 10 seconds then the steam

mop will return to the chosen setting.

Hints for optimum use

General

Caution! Never use the steam mop without rst attaching a

cleaning pad.

u During use you can use the cable management clip (10) to

keep your cable out of the way of the work area.

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the machine is to tilt the handle to

a 45˚ angle and clean slowly, covering a small area at a

time.

u Do not use chemical cleaners with your steam mop. To

remove stubborn stains from vinyl or linoleum oors, you

can use the steam burst button to apply extra steam to

the area or pre-treat with a mild detergent and some water

before using the steam mop.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker FSM 1630S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker FSM 1630S Manual

Product: