779811
5
Zoom out
Zoom in
Previous page
1/9
Next page
5
Unlatch the fan cover from the bottom of the
vacuum
housing by pressing the
release tab (located near the front of the
vacuum
housing) and pulling the
cover open like a lid (figure B1).
NOTE: This interlock will disconnect the
electric circuit automatically and the unit will
not operate.
Attach the vacuum tube assembly to the
fan inlet on the
vacuum
housing (figure
C), insert the vacuum tube support tab
into the assembly slot (figure C1) on the
blower housing.
Push the lock button to lock the vacuum tube in place.
NOTE: This interlock will connect the electric circuit automatically and the unit
will operate.
COLLECTION BAG ASSEMBLY (FIGURE D)
NOTE:
Ensure the vacuum is switched off and
disconnected from the power supply before
attaching or removing the collection bag.
Remove blower tube if attached.
Push the collection bag on to the blower
housing until the lock lever engages the lock
hole as shown in figure D.
OPERATION
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND
SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING
OUTDOORS. FOR HOUSEHOLD USE ONLY.
WARNING: CUT HAZARD. When turning the tool off for tube
installation or any other reason, wait 10 seconds for the fan to stop
rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and
collection bag in place.
Always switch off and remove the plug from the electrical supply when:
Changing from blower to vacuum.
BLOWER MODE ASSEMBLY
NOTE: Ensure the blower is switched off and disconnected from
the power supply before attaching or removing the blower tubes.
The tube assembly must be assembled to the housing before use.
TUBE ASSEMBLY (FIGURE A)
To attach the two piece blower tubes to the blower, line up the tube
with the blower housing as shown in figure A. Push the tube into the
blower housing until the lock lever engages the lock hole in the tube.
To rem
ove the tube depress the lock button and slide the tube off
the housing neck.
VACUUM MODE ASSEMBLY
VACUUM TUBE ASSEMBLY (FIGURES B, C, D)
NOTE:
Ensure the
vacuum
is switched off and disconnected from
the power supply before attaching
or removing the vacuum tube. The
vacuum tube and collection bag must be
assembled to the housing before use.
The vacuum tubes must be assembled
together before use.
Align the notches and the tabs on the two
tube pieces. (figure B)
Push the lower tube firmly into the upper
tube, until the tabs click into place. (Never
operate apart).
A
D
C
C1
B
B1
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker BV3100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker BV3100 in the language / languages: English as an attachment in your email.

The manual is 6.03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info