Manual Black Decker BDCD12 (page 6 of 88) (All languages)

661436

Zoom out

Zoom in

1/88

ENGLISH

(Original instructions)

Warning! Do not use tool while it is connected to the charger.

Warning! re Hazard. When disconnecting the charger from

the tool, be sure to unplug the charger from the outlet rst,

then disconnect the charger cord from the tool.

Installing and removing the battery pack from the

tool (g. B)

Warning! Make certain the lock-off button is engaged to

prevent switch actuation before removing or installing battery.

To install battery pack:

u Insert battery pack into tool, until an audible click is heard

(g. B)

Removing the battery pack from the tool (g. C)

u Depress the battery release button as shown in (g. C)

and pull battery pack out of tool.

Operating Instructions

Trigger switch & reversing button (g. D)

u The drill is turned ON and OFF by pulling and releasing

the trigger switch (1). The farther the trigger is depressed,

the higher the speed of the drill operates at

u A forward/reverse control button (2) determines the direc-

tion of the tool and also serves as a lock off button.

u To select forward rotation, release the trigger switch and

depress the forward/reverse control button to the left.

u To select reverse, depress the forward/ reverse control

button the opposite direction.

u To lock the tool, set the forward/reverse slider into the

centre position.

Note! The center position of the control button locks the tool

in the off position. When changing the position of the control

button, be sure the trigger is released.

Keyless chuck (g. E)

Warning! Make certain the lock-off button is engaged to

prevent switch actuation before installing or removing acces-

sories.

To insert a drill bit or other accessory:

u Grasp the rear half of the chuck (10) with one hand and

use your other hand to rotate the front half (11) in the

counterclockwise direction, as viewed from the chuck end.

u Insert the bit or other accessory fully into the chuck, and

tighten securely by holding the rear half of the chuck and

rotating the front portion in the clockwise direction as

viewed from the chuck end.

Warning! Do not attempt to tighten drill bits (or any other ac-

cessory) by gripping the front part of the chuck and turning the

tool on. Damage to the chuck and personal injury may occur

when changing accessories.

Drilling/screwdriving

u Select forward or reverse rotation using the forward/re-

verse slider (2).

u To switch the tool on, press the switch (1). The tool speed

depends on how far you press the switch.

u To switch the tool off, release the switch.

Hints for optimum use

Drilling

u Always apply a light pressure in a straight line with the drill

bit.

u Just before the drill tip breaks through the other side of the

workpiece, decrease pressure on the tool.

u Use a block of wood to back up workpieces that may

splinter.

u Use spade bits when drilling large diameter holes in wood.

u Use HSS drill bits when drilling in metal.

u Use masonry bits when drilling in soft masonry.

u Use a lubricant when drilling metals other than cast iron

and brass.

u Make an indentation using a centre punch at the centre of

the hole to be drilled in order to improve accuracy.

Screwdriving

u Always use the correct type and size of screwdriver bit.

u If screws are difcult to tighten, try applying a small

amount of washing liquid or soap as a lubricant.

u Always hold the tool and screwdriver bit in a straight line

with the screw

Troubleshooting

Problem Possible cause Possible solution

Unit will not start. Battery pack not

charged.

Check battery pack charg-

ing requirements

Battery pack will not

charge.

Charger not plugged

in.

Surrounding air

temperature too hot or

too cold.

Plug charger into a work-

ing outlet.

Move charger and battery

pack to a surrounding air

temperature of above 40

degrees F (45ºC) or below

105 degrees F (+40.5ºC)

Unit shuts off

abruptly.

Battery pack has

reached its maximum

thermal limit.

Out of charge. (To

maximize the life of

the battery pack it is

designed to shutoff

abruptly when the

charge is depleted

Allow battery pack to cool

down.

Place on charger

and allow to charge.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker BDCD12 in the language / languages: All languages as an attachment in your email.

The manual is 2,02 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Black Decker BDCD12 Manual

Product: